Aquaport AQP-BM4 Manuel d'installation et d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Aquaport AQP-BM4. Aquaport AQP-BM4 12 pages. Deluxe collection water cooler cold and room

Imprimer la page

A. Water Cooler Installation for Spring Water bottles.

Please follow the instructions below if you are using a spring

water bottle.

Do not turn on the water cooler until the following instruction

have been followed.

1. Vertically insert a spring water bottle into the bottle support

on top of the water cooler, the spike will pierce the bottle cap.

You will see bubbles appear inside the bottle, wait until the

bubbling has stopped before dispensing water from both taps.

Note: If you are applying a spring water bottle to the water cooler

for the ﬁ rst time and you do not see any bubbles appear inside

the bottle, open both taps until the bubbling starts and water

ﬂ ows from both taps. Refer to the trouble shooting guide for more

information.

2. Once the bubbling has stopped, drain 1-2lts of water

from both taps.

Note: The water cooler has been ﬂ ushed before it left the factory

however we strongly recommend 2-3lts of water is ﬂ ushed through

the unit before using.

3. Insert the power plug into the wall socket, and turn the power/

cooling switch ON. The power/cooling switch is situated at the

rear of the unit.

4 INSTALLATION AND OPERATING INSTRUCTIONS

4. At the front of the unit there are 3 indicator lights, the POWER

light will continually illuminate while the unit is turned on.

The COOLING light in the middle will illuminate when the

compressor is running and cooling the water. When cooling is

ﬁ nished the COOLING light will turn off and the COLD auxiliary

light will illuminate until cooling is required again.

5. When the unit is turned on for the ﬁ rst time, allow the unit to

cool the water for 1-2 hours before dispensing cold water.