Aquaport AQP-TAP-4S Manuel d'installation et d'utilisation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Aquaport AQP-TAP-4S. Aquaport AQP-TAP-4S 14 pages. Filtered water sink mixer 4 way tap

10. Place the 1/4 inch Quick Connection Black O-ring (12) into
the 1/4 inch Quick Connection Piece (13), and screw 1/4 inch
Quick Connection Piece onto the ends of the Ambient and Cold
Filtered Water Shanks (4 & 5).
Note: Hand tighten connections only, as cross threading can occur.
If leaks occur, apply sealing tape in a clockwise direction and
reconnect fittings. Do not apply sealing tape in a counter clockwise
direction, it releases the tape.
11. Locate the Flexible Metal Connector (9) connected to the
Mains Cold Water Connection (2) inlet on the tap and connect
the Flexible Hose Connector to the mains cold water
supply line.
12. Locate the Flexible Metal Connector (9) connected to the
Mains Hot Water Connection (3) inlet on the tap and connect
the Flexible Hose Connector to the mains hot water supply line.
IMPORTANT: Re-check to make sure hot and cold mains water
connections are correct.
13. Connect Tubing connections from your filtration system and
undersink chiller to the ends of the Quick Connection Pieces
connected to the ends of the Ambient and Cold Filtered
Water Shanks (4 & 5).
Note: Refer to section D. Tubing Installation
6 INSTALLATION AND OPERATING INSTRUCTIONS
14. Before turning on mains water supply, open the tap Mains
Water Hot & Cold Levers (7) midway between full hot and full
cold and remove the Aerators (8) from the tap outlets.
15. Turn "ON" the mains water supply and thoroughly flush water
through the supply lines and the tap.
16. Turn the tap water levers "OFF", reinstall the Aerators (8) and
check for any leaks.
Note: Connections may need to be reinstalled
and tightened slightly.
Customer Care Line: 1300 764 325