AquaPRO 02AS003B Instructions - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} AquaPRO 02AS003B. AquaPRO 02AS003B 4 pages. Water feature pump
Imprimer la page
IMPORTANT SAFEGUARDS
IMPORTANT: IF USED IN MARINE OR
SALTWATER, DUE TO THE HARSH
CONDITIONS THE WARRANTY IS VOID.
To guard against injury, basic safety precautions should
be observed including, but not limited to the following:
• The pump should only be used in clean water. Do
not use the pump in any solvent or gasoline that is
flammable.
• Do not operate the pump without water at any time,
permanent damage may occur.
• Do not operate the pump if the pump or any of the
components of the pump, such as the power cable,
have been damaged.
• The drip loop method should be used to prevent
water from traveling down the cord onto the plug
or power point. If the plug does get wet, do not
unplug the cord. Disconnect the circuit breaker
that supplies power to the power point. Then unplug
and examine the plug and power point for presence
of water. If the power point has become wet, you
should consult an electrician before using the power
point again.
• Always use a properly grounded power supply
that is connected to an RCD with a rated residual
operating current not exceeding 30mA. As per AS/
NZS 3350.2.41:1997.
• Always unplug the pump from the power supply
when not in use or before performing any
maintenance on the pump. Never pull the cord to
disconnect the plug from the power supply. Grasp
the plug and pull to disconnect.
• Do not install or store the pump where it will be
exposed to extreme hot or cold temperatures.
• Do not cut the cord as this will result in voiding your
warranty.
• Care should be taken to arrange the power cord so
that it cannot be accidentally tripped over or pulled.
• Do not attempt to repair the pump yourself. Return
to an authorised service centre o place of purchase
if a fault occurs.
• Do not use in water above 35°C.
HOTLINE
AQUAPRO AP1050/AP3000 Instructions.indd 4
AQUAPRO AP1050/AP3000 Instructions.indd 4
1300 278 283
EMAIL
WWW.AQUAPROONLINE.COM.AU
WARRANTY
WARRANTY COVERS ONLY APPLIANCE
DEFECTS, FAULTY MATERIAL AND
WORKMANSHIP WITHIN A 2 YEAR PERIOD.
• Faults arising due to; accidents, misuse, not
following manufacturer's guidelines/ instructions, or
power surges/spikes/ brownouts will not be covered.
• The impellor set is a consumable item and is
therefore not covered under warranty.
• Warranty will be void if any tampering, removal of
warranty labels, or electrical circuitry is evident.
• Warranty will be void if the power cord is cut or
damaged in any way.
• Warranty will be void if any visible signs of
overheating are present.
• Loss of livestock, damage to property or personal
injury caused by this product will not be covered.
• Warranty claims caused by installation faults will not
be covered.
• It is the customer's responsibility to return the faulty
appliance for any warranty claim to Aquatec.
• For any warranty to be valid, an original proof of
purchase must be provided.
• Our goods come with guarantees that cannot be
excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a
major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure
does not amount to a major failure.
FOR MORE INFORMATION AND THE
COMPLETE AQUAPRO RANGE
VISIT WWW.AQUAPROONLINE.COM.AU
+61 (8) 6260 1000
PHONE
22/9/21 1:54 pm
22/9/21 1:54 pm