Burley d'lite Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Burley d'lite. Burley d'lite 12 pages. Child trailers
Également pour Burley d'lite : Manuel d'instruction et de sécurité du propriétaire (15 pages), Brochure & Specs (5 pages), Manuel d'instruction et de sécurité du propriétaire (12 pages), Manuel d'instruction et de sécurité du propriétaire (8 pages), Manuel d'instruction et de sécurité du propriétaire (20 pages), Manuel d'utilisation et de sécurité (8 pages), Manuel d'instruction et de sécurité du propriétaire (12 pages), Manuel d'instruction et de sécurité du propriétaire (16 pages)

Imprimer la page
Burley d'lite Manuel de l'utilisateur
Re-Assembly with the Pivot Wheel
• Slide the wheel pivot assembly over the end of the tongue so that the hole in the
tongue lines up with the hole in the top as shown below.
• Line the hitch connector hole #4 with those same two holes.
• Run the 2-inch bolt provided through the d-ring, and then through the Wheel
pivot assembly, tongue hitch connector.
1
2
3
• Push the bolt through the hole at the bottom, visible in the cavity underneath, and
then secure with the new locking nut provided (tighten to 6 ft-lbs). The end of the
bolt should be fl ush or completely pass through the end of the nut.
• Place the 1-inch bolt (#2) using 2 washers as shown and a locking nut.
• Then place the other 1-inch bolt (#3) through one washer and the remaining hole.
• On the underside of #3 place the safety strap and a locking nut.
• Tighten to 6 ft-lbs using the torque wrench. The end of the bolt must be fl ush with
or completely pass through the nut.
When installed the hitch is re-attached by the bolt
that goes through the tongue (and hitch's fl exible
coupling); the safety strap is anchored, and the
d-ring is on top.
Note: If using the Burley Alternative Hitch,
the fl exible coupling is attached in the same
manner, using the bolt through the tongue.
The safety strap is anchored in the same way,
to the wheel assembly clamp bolt.
8
Burley Walk 'n Roller Manual; models 2003 and earlier
4
5