Burley NOMAD RACK Manuel du propriétaire et manuel de sécurité - Page 5

2.5"

right

rear

Correct

IV.

Setting Up and Folding Your Burley

Nomad

Setting up or folding your Burley Nomad is ac com plished in a few easy steps

involving the side rails, the roll bar and cover, the tongue, and the safety ﬂ ag.

Ensure that all four of the plas tic side-panel hold-downs (C-shaped) on the main

frame are ﬂ ipped to the outside of the Burley Nomad (see illustration). Slide each

side rail down over the 2" tall alu mi num side rail guides at the front and rear of each

side of the main frame.

Take care that you put the prop er side panel assembly on each side, each with the

trademark "Burley" facing outward. Next, snap each side-panel assembly into place

with the plastic side-panel hold-downs at the front and rear of each side as shown

on next page. The large end of the side rails face forward.

The reﬂ ector brackets mount on the outside of

each side panel, 2.5" up from the plastic connec-

tor on the side panel. The holes for the mounting

screws are covered by the fabric.

First, insert the screw into the reﬂ ector bracket and

drive the Phillips-head self-tapping screws through

the fabric into the holes provided to mount the

bracket. (Don't worry; this won't harm the fabric.)

Then mount the red reﬂ ectors onto the brack-

ets with the slotted-head, self-tapping reﬂ ector

mounting screws. The bracket should be mounted

as shown in the illustrations.

Install Side Rails

Burley Nomad Owner's Instruction and Safety Manual

Wrong