Burlington Boat T6C Manuel de démarrage rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Burlington Boat T6C. Burlington Boat T6C 2 pages.

● There are two ways in which you can connect the drain pipe to the waste.

Method 1) If you have a waste that comes up through the floor, you can connect to it

with a flexible drain pipe which enables you to tilt the bath up and move the

bath into the required position. To avoid water retention in the trap

the flexible pipe should have a continuous downward flow

● Place the bath on two wooden blocks over the waste connections.

● Connect the waste. Fill the bath with water and check for leakage.

● The rigid pipe should be connected to the drain pipe outside bath.

● Connect the waste. Fill the bath with water and check for leakage.

Method 2) If under-floor access is impossible, an additional hole of approx 45mm

● Securing your bath to the floor!!!

When the bath is in position and the installation is complete, It is recommended

back view

that you apply a bead of clear silicone sealant around the bottom of the bath to

secure it to the floor.

● Should maintenance access be needed the silicone can be released by cutting

round it with a sharp knife.

2 - 2

diameter can be drilled through the outer skin of the bath to allow the trap

to be connected to a rigid pipe.

24H