Chrosziel Magnum MN-101 Manuel de référence rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de référence rapide pour {nom_de_la_catégorie} Chrosziel Magnum MN-101. Chrosziel Magnum MN-101 2 pages.

Imprimer la page
Record Trigger
select whether hand unit with ID 1 or 2
can trigger the record signal
Enabled ID:
1
Matching :
Mode: < Pulse >
select mode entry and modify trigger
mode with -/+ buttons
Start
Stop
*setting is stored in the motor box in the
non volatile memory and is editable on
Save&Exit
Cancel
hand unit ID 2 as well
Motor 1-4: Enter configuration menu of
Motor Setup
the two on-board motor channels (1-2)
Motor 1 (F)
and the 2 optional extended motor
Motor 2 (I/Z)
channels (3-4) (MN-200R only)
Motor 3
Motor 4
< Back
Servo Lens Setup(MN-200R only)*:
Select the configuration fields for F/I/Z
Servo Lens Setup
with up/down buttons and adjust each
Z:
F:
on
I:
on
off
entry to "on" or "off" with left/right"
buttons. If "on" Magnum
takes over control of the desired internal servo motor.
"Z" is switched off by default but can be activated as well. If so, a
connected zoom demand controller on the 12pin Hirose socket of the
MagNum motor controller controls the zoom servo motor of the servo
lens. If "I" is switched to "off" the camera can control the iris through the
camera lens port if applicable.
*Setting is stored in the motor box in the non-volatile memory and is
editable on hand unit ID 2 as well
Record Trigger
Scales
10
Calibrate Motors
Reader ft /in
10/ 6"
Brain. Pow.: 13.5V
sw sw
M
M
1
sw sw
*Display can be disabled/enabled
on menu entry "Display Options"
Reverse Wheel
off
Reverse Slider
off
Save & Exit
Cancel
M1 Set Up
Link to: Assigned function (Focus / or Iris)
Direction : Reverse motor direction
Save & Exit
Cancel
Torque: Reduce torque of the motor to mid
F
Link to
(50%) or low (25%).
Direction
norm
Lens Type: Cine = end stops will be
Full
Torque
calibrated automatically; Photo = end stops
are calibrated manually.
Photo
Lens Type
Mode: Switch to dimmer mode here.
1/2
Dimmer cable can be controlled.
Play: Modify play (backlash) compensation
M1 Set Up
for heavily used motors with a large amount
of play in the gearbox.
Mode
motor
Safety: Modify the safety distance, the
Play
0
motor stays away from the mechanical Lens
Safety
0
End Stops (S3D Rigs).
Range: Switch to 3D Rig mode if required
Range
Lens
2/2
*Setting is stored in the motor box in the non-volatile memory and is
editable on hand unit ID 2 as well
Setup
English
Radio Channel
Record Trigger
Scales
Assign U Keys
Calibrate Motors
Zoom Function
on
1/2
Setup
Motor Setup
Motor Booster
Load Defaults
Setup Hand Unit
2/2
Motor Calibration
Cal. Mot1(F)
Cal. Mot2(I)
Cal. Mot3(I)
Cal. Mot4(F)
< BACK
Set Up Hand Unit
Ctrl. ID < >
1
Left-Handed
no
Serial Socket
Display Options
Load Defaults
Enable features
Wheel/Slider Cal.
< Back
*Setting is stored in the Hand Unit and is
independent from Setting in HU 2.
Set Radio
Chan.:
8
Freq. :
2422.75
Spectrum