Aquasana Claryum AQ-MF-1 Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Aquasana Claryum AQ-MF-1. Aquasana Claryum AQ-MF-1 12 pages. Under sink water filter
Également pour Aquasana Claryum AQ-MF-1 : Manuel du propriétaire (12 pages)
Imprimer la page
Performance Data Sheet for the Aquasana Claryum
Models
Replacement
AQ-MF-1-R
AQ-MF-1
Manufactured by: Aquasana, Inc. 6310 Midway Road · Haltom City, Texas 76117 · 866.662.6885
Testing Performed under NSF/ANSI Standards 42 and 53 and in accordance with the California Department of Health Services Drinking Water Treatment
Device Program. This system has been tested according to NSF/ANSI 42, 53 & 401 for reduction of the substances listed below. The concentration of the
indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system,
as specified in NSF/ANSI 42, 53 & 401.
NSF/ANSI 42
Chlorine Reduction, Free Available
Chloramine Reduction, Free Available <0.5 mg/l
Particulate Reduction
NSF/ANSI 53
Cyst Live Cryptosporidium & Giardia 99.95%
Mercury Reduction pH 8.5
Mercury Reduction pH 6.5
Lead Reduction pH 6.5
Lead Reduction pH 8.5
MTBE Reduction
Turbidity
VOC Surrogate Test
Asbestos
Perfluorooctanoic acid (PFOA) &
Perfluorooctane sulfonate (PFOS)
Maximum
NSF/ANSI 401
Concentration
Atenolol
30 ng/L
Bisphenol A
300 ng/L
Carbamazepine
200 ng/L
DEET
200 ng/L
Estrone
20 ng/L
Ibuprofen
60 ng/L
Linuron
20 ng/L
Meprobamate
60 ng/L
Metolachlor
200 ng/L
Naproxen
20 ng/L
Nonyl phenol
200 ng/L
Phenytoin
30 ng/L
TCEP
700 ng/L
TCPP
700 ng/L
Trimethoprim
20 ng/L
System Tested and Certified by IAPMO R&T lab and IAPMO R&T against
NSF/ANSI Standards 42, 53 & 401 and conforms to NSF Protocol as
verified and substantiated by test data. Please refer to Performance
Data Sheet for specific contaminant reductions.
• All contaminants reduced by this filter are listed.
• Not all contaminants listed may be present in your water.
• Does not remove all contaminants that may be present in tap water.
Filter is only to be used
with cold water.
Filter usage must comply
with all state and local laws.
Testing was performed under
standard laboratory conditions,
actual performance may vary.
®
Operating pressure range
Rated capacity
10-125 psi
784 gallons
68.95-861.8 kPa
2,967 liters
Min Reduction
Overall % Reduction
<0.5 mg/l
96.06%
96.06%
85%
99.9%
Min Reduction
Overall % Reduction
>99.95%
<2 ug/L
>96.7%
<2 ug/L
>96.6%
<10 ug/L
>99.4%
<10 ug/L
>99.3%
<5 ug/L
86.6%
<0.5 NTU
99.1%
95%
99.4%
99%
>99%
0.07 ug/L
95.8%
Minimum
Overall % Reduction
Reduction
94.2%
94.2%
98.80%
98.9%
98.6%
98.6%
98.7%
98.7%
96.30%
96.5%
95.3%
95.4%
96.6%
96.6%
94.7%
94.7%
98.6%
98.6%
96.3%
96.4%
97.50%
97.5%
95.50%
95.6%
98%
98%
97.8%
97.8%
96.7%
96.7%
Systems certified for cyst reduction
may be used on disinfected waters
that may contain filterable cysts.
See owner's manual for general
installation conditions and
needs plus manufacturer's
limited warranty.
Direct Connect Water Filter
Operating temp. range
35-100 F
1.66-37.78 C
Results
Organic chemicals included by surrogate testing
VOCs
Pass
(by surrogate testing
Pass
using chloroform)
Pass
alachlor
Results
atrazine
Pass
benzene
Pass
carbofuran
carbon tetrachloride
Pass
chlorobenzene
Pass
chloropicrin
Pass
2,4-D
Pass
dibromochloropropane (DBCP) 0.0002
o-dichlorobenzene
Pass
p-dichlorobenzene
Pass
1,2-dichloroethane
Pass
1,1-dichloroethylene
cis-1,2-dichloroethylene
Pass
trans-1,2-dichloroethylene
1,2-dichloropropane
cis-1,3-dichloropropylene
Results
dinoseb
endrin
Pass
ethylbenzene
Pass
ethylene dibromide (EDB)
Pass
haloacetonitriles (HAN)
bromochloroacetontrile
Pass
dibromoacetontrile
Pass
dichloroacetontrile
Pass
trichloroacetontrile
haloketones (HK)
Pass
1,1-dichloro-2-propanone
Pass
1,1,1-trichloro-2-propanone
Pass
heptachlor (H-34, Heptox)
Pass
heptachlor epoxide
hexachlorobutadiene
Pass
hexachlorocyclopentadiene
Pass
lindane
Pass
methoxychlor
pentachlorophenol
Pass
simazine
Pass
styrene
1,1,2,2-tetrachloroethane
tetrachloroethylene
toluene
2,4,5-TP (silvex)
tribromoacetic acid
1,2,4-trichlorobenzene
1,1,1-trichloroethane
1,1,2-trichloroethane
trichloroethylene
trihalomethanes (THMs)
bromodichloromethane (THM)
bromoform (THM)
chloroform (THM)
chlorodibromomethane (THM)
xylenes (total)
Rated flow
1.5 gpm
5.67 lpm
Drinking
Influent/
water
Unfiltered
regulatory
level (MCL/
MAC) mg/L
0.002
0.050
0.003
0.100
0.005
0.081
0.04
0.190
0.005
0.078
0.1
0.077
—
0.015
0.07
0.110
0.052
0.6
0.080
0.075
0.040
0.005
0.088
0.007
0.083
0.07
0.170
0.1
0.086
0.005
0.080
—
0.079
0.007
0.170
0.002
0.053
0.7
0.088
0.00005
0.044
—
0.022
—
0.024
—
0.0096
—
0.015
—
0.0072
—
0.0082
0.0004
0.025
0.0002
0.0107
—
0.044
0.05
0.060
0.0002
0.055
0.04
0.050
0.001
0.096
0.004
0.120
0.1
0.150
—
0.081
0.005
0.081
1
0.078
0.05
0.270
—
0.042
0.07
0.160
0.2
0.084
0.005
0.150
0.005
0.180
Influent/
Unfiltered
0.080
0.300
10
0.070
For use with municipally treated water only. Do not
use with water that is microbiologically unsafe or of
unknown water quality without adequate disinfection
before or after the system.
Effluent/
Percent
Filtered
Reduction
0.001
>98%
0.003
>97%
0.001
>99%
0.001
>99%
0.0018
98%
0.001
>99%
0.0002
99%
0.0017
98%
0.00002
>99%
0.001
>99%
0.001
>98%
0.0048
95%
0.001
>99%
0.0005
>99%
0.001
>99%
0.001
>99%
0.001
>99%
0.0002
99%
0.00059
99%
0.001
>99%
0.00002
>99%
0.0005
98%
0.0006
98%
0.0002
98%
0.0003
98%
0.0001
99%
0.0003
96%
0.00001
>99%
0.0002
98%
0.001
>98%
0.000002 >99%
0.00001
>99%
0.0001
>99%
0.001
>99%
0.004
>97%
0.0005
>99%
0.001
>99%
0.001
>99%
0.001
>99%
0.0016
99%
0.001
>98%
0.0005
>99%
0.0046
95%
0.0005
>99%
0.0010
>99%
Effluent/
Percent
Filtered
Reduction
0.015
95%
0.001
>99%