AquaScape 77020 Instructions d'installation et entretien - Page 5
Parcourez en ligne ou téléchargez le pdf Instructions d'installation et entretien pour {nom_de_la_catégorie} AquaScape 77020. AquaScape 77020 16 pages. Pond waterfall filter
Également pour AquaScape 77020 : Instructions et entretien (16 pages)
Imprimer la page
STEP 7
POSITION THE FILTER
• Position the filter along the perimeter of the pond with the
spillway pouring back into the water (Ex. 10). The filter can
also be positioned on top of a waterproof liner to guide
water back into the pond.
TIP: If needed, use a soil tamper or cinder block to
compact the ground beneath the filter, preventing
future settling.
• Use a 3-foot level to ensure the filter is level from side-to-
side and tilted forward a 1/4 bubble.
STEP 8
ATTACH PIPE TO FILTER FITTING
• Attach 1", 1.25", or 1.5" pipe (not included) to the fitting
at the back of the filter (Ex. 11). It is recommended to use
a hose clamp (not lincluded) to secure the pipe onto the
fitting (Ex. 12).
Ex. 11
TIP: In some instances the pipe/tubing may be tight
or difficult to connect to the fitting. If this is the case,
it is recommended to heat the hose with a hair
dryer or dip it for a few seconds in very hot water.
Lubrication such as silicone grease or olive oil can
also be used.
TIP: Use as large of a diameter of pipe as possible
to achieve maximum water flow. If using a pipe
diameter larger than the smallest section of the
fitting, trim off the smaller sections to avoid flow
restriction (Ex. 13).
☎
aquascapeinc.com |
CAN (866) 766-3426 |
Hosetail ready for 1" tubing
Hosetail ready for 1½" tubing
Ex. 10
STEP 9
ATTACH PIPE TO WATER PUMP
• Attach the other end of the pipe to the selected water
pump (Ex. 14) (not included). It is recommended to use a
hose clamp (not included) to secure the tubing onto the
fitting (Ex. 15).
Ex. 12
☎
US (866) 877-6637
Hosetail ready for 1¼" tubing
CUT
HERE
Installation of stainless
steel hose clamp
stainless steel
CUT
hose clamp
HERE
Ex. 14
Kink-Free
Tubing
Ex. 13
Ex. 15
5