Aquascape Pro 7500 Manuel d'installation et d'entretien - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'entretien pour {nom_de_la_catégorie} Aquascape Pro 7500. Aquascape Pro 7500 16 pages.

Imprimer la page

1. Electrical Connections

• Do not pump hazardous materials (flammable, caustic, etc.).

• Do not block or restrict discharge hose, as discharge hose may whip under pressure.

• Make sure lifting handles are securely fastened each time before lifting.

• Do not exceed manufacturers recommendation for maximum performance, as this could

cause the motor to overheat.

• Secure the pump in its operating position so it can not tip over, fall or slide.

• Submersible Pumps are not approved for use in swimming pools.

• Do not operate pump without safety devices in place. Always replace safety devices that

have been removed during service or repair.

• Any wiring of pumps should be performed by a qualified electrician.

• Cable should be protected at all times to avoid punctures, cut, bruises and abrasions–

inspect frequently.

• Never handle connected power cords with wet hands.

• Do not remove cord and strain relief. Do not connect conduit to pump.

• To reduce risk of electrical shock, all wiring and junction connections should be made per

the NEC or CEC and applicable state or province and local codes. Requirements may vary

depending on usage and location.

• Use only in fully assembled state.

IMPORTANT! Aquascape, Inc. is not responsible for losses, injury, or death resulting from a

failure to observe these safety precautions, misuse or abuse of pumps or equipment.

General Information

IMPORTANT! Read all instructions in this manual before operating pump.

3) receiving

Upon receiving the pump, it should be inspected for damage or shortages. If damage has

occurred, file a claim immediately with the company that delivered the pump. If the manual

is removed from the packaging, do not lose or misplace.

4) Installation

Location:

These pumping units are self-contained and are recommended for use in an Aquascape

skimmer or snorkel, sump, lift station or basin. This pump is designed to pump pond water

and shall NOT be installed in locations classified as hazardous in accordance with the

National Electrical Code (NEC), ANSI/NFPA 70 or the Canadian Electrical Code (CEC). Never

install the pump in a trench, ditch or hole with a dirt bottom; the legs will sink into the dirt

and the suction will become plugged.