Panasonic CT-27G7SDUF Manuel d'entretien - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Panasonic CT-27G7SDUF. Panasonic CT-27G7SDUF 28 pages.
IMPORTANT SAFETY NOTICE
THIS
SCHEMATIC
DIAGRAM
FEATURES THAT ARE IMPORTANT FOR PROTECTION FROM
X-RADIATION, FIRE AND ELECTRICAL SHOCK HAZARDS.
WHEN
SERVICING
IT
IS
MANUFACTURERS SPECIFIED PARTS BE USED FOR THE
CRITICAL COMPONENTS DESIGNATED WITH A
SCHEMATIC.
1. Resistors are carbon 1/4W unless noted
otherwise.
2. Capacitors are ceramic 50V unless noted
otherwise.
3. Coil value notes is inductance in µH.
4. Test point indicated by
; Test point but no
pin .
5. Components indicated with
parts and replacement should be made
with manufacture specified replacement
parts only.
1. Voltage measurement:
-
AC input to the Receiver is 120V.
NTSC (HD, 1125i & 525P when
applicable)
signal
connected to the antenna of the
Receiver. (Color bar pattern of 100
IRE white and 7.5 IRE black.)
-
All Picture and Audio adjustments are
set to Normalize.
TV ANT/CABLE - (Set-Up Menu) in
TV/ANT Mode
Volume - Min.
TV/Video SW - TV position
Audio Mode - Stereo
3
1.
indicates
waveform
(Measurement can be taken at the best
accessible location in common to the
indicated point.)
2. Taken with an NTSC signal generator
connected
to
the
antenna
(NTSC color bar pattern of 8 bars of EIA
colors, 100 IRE white and 7.5 IRE black.)
3. Customer Controls (Picture/Audio Menu) are
set to Normalize. Volume is set to "MIN".
Schematic Notes
INCORPORATES
SPECIAL
ESSENTIAL
THAT
ONLY
IN THE
SCHEMATIC NOTES
6.
of B+ supply.
7. The schematic diagrams are current at
the time of printing and are subject to
change without notice.
8. Ground
GROUND
are critical
indicates COLD GROUND.
NOTE: All other component symbols are
VOLTAGE MEASUREMENTS
-
generator
is
-
2. Ground symbol
connection of meter.
Incorrect ground connection will result
in erroneous readings.
CAUTION: Incorrect ground connection
of the test equipment will result in
erroneous readings.
WAVEFORM MEASUREMENTS
measurement.
4. All video and color waveforms are taken
with a wideband scope and a probe
with low capacitance (10 to 1). Shape
and
depending on the type of Oscilloscope
terminal.
used and its settings.
5. Ground symbol
number indicates (Hot) ground lead
connection of the Oscilloscope.
CAUTION: Incorrect ground connection of
the test equipment will result in erroneous
readings.
- 14 -
CHIP TRANSISTOR
LEAD DESIGNATION
B
C
E
(BOLD LINE) indicates the route
symbol
indicates
HOT
CONNECTION;
used
for
engineering
design
purposes.
Voltage readings are nominal and
may vary ±10% on active devices.
Some voltage reading will vary
with signal strength and picture
content.
Supply voltages are nominal.
indicates ground lead
peak
altitudes
may
shown on waveform
vary