Diamond Ground Products DGP-PG2-A Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Diamond Ground Products DGP-PG2-A. Diamond Ground Products DGP-PG2-A 12 pages. Tungsten electrode grinder

Imprimer la page

NOTCHING YOUR ELECTRODE

The notching feature is located at the right hand side

of your unit. This feature is provided to notch your

electrodes to a point where they can be split in half or

to remove any existing contamination off of a spent

electrode. You should never snap your electrode in half

without notching it first. Snapping your electrode will

cause splintering within your electrode, which will later

result in contamination in your weld.

• Insert your electrode through the slot opening and

push through so the electrode is exiting from opposite

end. Holding both ends, push the electrode towards

the corner of the rotating wheel.

• Once you have notched a sufficient amount of your

electrode on one side, rotate the electrode to notch the

remaining side.

• Once complete, use the Tip/Flat Block to flatten your

electrode and proceed to grind as normal.

ADJUSTING THE SLIDING

DUST SHIELD

Turn the dust shield knob counter-clockwise to unlock.

Depending on the angle desired, slide the shield

forward or backward and align the edge of the shield

to the inner face of the electrode arm. Dust escapes not

from the holes, but the space between the wheel and

the electrode arm. Turn the dust shield knob clockwise

to lock the shield in place. Remember to adjust the

shield if adjusting the angle.

Page 7