Diamond H2O DCF6-250-100 Manuel d'installation, d'utilisation et d'entretien - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Diamond H2O DCF6-250-100. Diamond H2O DCF6-250-100 18 pages. Activated carbon water filter system

Imprimer la page

5. CONTROL VALVE INSTRUCTIONS continued

5.5.

OEM GENERAL INSTRUCTIONS continued

Table 1 shows the time for the backwash, regenerative, and rinse cycles for the ten available

programming options. Six different programs are available for a softener, one for a regenerative

filter, and three programs for backwash only filters. When the control valve is used as a:

Softener: one or two backwashes occur and refill always occurs after the rinse cycle (P0 - P5)

Regenerative Filter: one backwash occurs and refill always occurs after the rinse cycle (P6)

Backwashing Filter: one backwash occurs (P7 through P9)

Program

Backwash

NOTE: Diamond H

O used P9 as the default.

NOTE: During regeneration the display will show C1, C2, etc. If the cycle is skipped, that cycle

number will not be displayed.

STEP 3SS:

If program P0 through P6 was selected, enter in the

minutes of fill using ▲ or ▼. The allowable values

vary from a low of 1 to a high of 99. If program P7,

P8 or P9 was selected, this screen will not appear.

Press SET button to go to Step 4SS. Note: For each

minute of fill 0.5 gallons of water is added to the

solution tank. With Sodium Chloride, each 0.5 gallon

of water will dissolve 1.5 pounds of salt.

N1022 Quality Drive

Regeneration Cycles and Times for Different Programs

All times in Minutes

Regenerate

Skipped

Diamond H2O

PO Box 170

Ph: (920) 757-5440 / (866) 757-9287 / Fax: (920) 757-5819

Table 1

Backwash

Rinse

Skipped

Greenville, WI 54942

Fill

1-99

Skipped

Page 9