Panasonic DMC-FT5 Manuel d'utilisation de base - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation de base pour {nom_de_la_catégorie} Panasonic DMC-FT5. Panasonic DMC-FT5 36 pages. Digital camera
Également pour Panasonic DMC-FT5 : Manuel de connexion (2 pages), Manuel d'utilisation de base (40 pages), Manuel du propriétaire (43 pages)
Imprimer la page
Using the camera underwater
•
Use the camera underwater to 13 m with the water temperature between 0 oC and 40 oC.
•
Do not use for scuba diving (Aqualung).
•
Do not use the camera at a depth of over 13 m.
•
Do not use it in the hot water over 40 oC (in the bath or hot spring).
•
Do not use the camera underwater longer than 60 minutes continuously.
•
Do not open or close the side door underwater.
•
Do not apply shock to the camera underwater. (Waterproof performance may not be
maintained, and there is a chance of water leak.)
•
Do not dive into the water holding the camera. Do not use the camera in a location where the
water will splash strongly, such as rapid flow or waterfall. (Strong water pressure may be
applied, and it may cause malfunction.)
•
The camera will sink in the water. Take care not to drop the camera and lose it underwater by
securely placing the strap around your wrist or similar measure.
Caring of the camera after using it underwater
Do not open or close the side door until the sand and dust is removed by
rinsing the camera with water.
Make sure to clean the camera after using it.
•
Thoroughly wipe off any water droplets, sand, and saline matter on your hands, body, hair,
etc.
•
It is recommended to clean the camera indoors, avoiding places where water spray or
sand may fall.
After using it underwater, always clean the camera rather than leaving it in a
dirty state.
•
Leaving the camera with foreign objects or saline matter on it may cause damage,
discolouration, corrosion, unusual odour, or deterioration of the waterproof performance.
1
Rinse with water with the side door closed.
•
After use at the seaside or underwater, soak the unit in fresh
water pooled in a shallow container for 10 minutes or less.
•
If the zoom button or camera [ON/OFF] button do not move
smoothly, it may be caused by an adhesion of foreign
objects. Using in such a state may cause malfunctions, such
as locking up, so wash off any foreign objects by shaking the
camera in fresh water.
•
Bubbles may come out of the drainage hole when you
immerse the camera in water, but this is not a malfunction.
11
(ENG) VQT4U14