Aquatec Equipment AQUAPRO AP300SP Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Aquatec Equipment AQUAPRO AP300SP. Aquatec Equipment AQUAPRO AP300SP 13 pages. Solar panel & submersible pump kit

Imprimer la page

PRODUCT SPECIFIC SAFEGUARDS

• Do not operate the pump without water at any time, permanent damage may occur.

• Be sure the equipment is submerged completely in the water. Do not use this pump in a dry mounted

application.

• The pump is designed to be used in a fresh water bird bath or water-feature. It is not to be used in

any other manner or purpose. The pump should only be used in clean water. Do not use the pump in,

or with, any chemicals such as a solvent or gasoline.

• Aquapro DC Solar Pumps are cooled by water flowing through the inside of the motor body. If the

pump flow becomes restricted it will overheat and could cause permanent damage. The pump needs

to be cleaned regularly to prevent the pump becoming blocked, thus causing the pump to overheat

and burn out. This is not a warrantable event. The flow rate through the pump needs to be strong

enough so that a half of the rated max flow is kept running at all times.

• Do not connect the pump to any AC voltage power supply. It is only to be supplied with DC power

within the voltage range stated in the specification table.

• The solar panel is made with glass components. Do not drop strike or crush the solar panel. It will

break. The solar module should only be cleaned with soft tissue or glass cleaning solutions.

• It is recommended that we should not to select a pump that is too small for the Job required. If in

doubt select a bigger model.

INSTALLATION

The solar pump is designed for outdoor or indoor fountain use, and is powered by a solar panel. In order

to make the pump work by solar energy, the solar panel needs to be placed in direct sunlight with its

solar cells facing the sun as much as possible. The performance of the pump depends on the sunlight

intensity and the incident angle at which sunlight strikes the panel surface.

The pump has the build-in function of dry-run protection. The dry-run protection function is provided by

two sensor points on one side of the pump housing (referring Diagram). The pump works if both of the

points are submerged in water. If either or both points emerge out of water, the pump stops working.

The motor unit of the pump is

encapsulated with epoxy resin and

does not need lubrication. Regular

inspections, cleaning and maintenance

of impellor is necessary to ensure

longer life.

In the centre of the impellor you

may notice a small hole opening that

protrudes through the ceramic shaft

from front to back. It is paramount

that this portal is kept unblocked at

all times. This is a cooling channel for

the motor.

The pump flow rate can be adjusted

by the flow valve on the front of the

pump.

AP300_960_1360 Instructions.indd 4

A Q U A T E C E Q U I P M E N T . C O M

31/5/18 12:25 pm