HP 316095-B21 - StorageWorks Edge Switch 2/24 Note de mise à jour - Page 10

Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} HP 316095-B21 - StorageWorks Edge Switch 2/24. HP 316095-B21 - StorageWorks Edge Switch 2/24 23 pages. Edge switch release notes
Également pour HP 316095-B21 - StorageWorks Edge Switch 2/24 : Manuel de mise à jour (9 pages), Manuel (41 pages), Manuel (40 pages), Note de mise à jour (32 pages), Note de mise à jour (27 pages), Manuel (26 pages), Note de mise à jour (27 pages), Note de mise à jour (25 pages), Manuel d'instructions d'installation (24 pages), Note de mise à jour (23 pages), Note de mise à jour (22 pages), Note de mise à jour (23 pages), Note de mise à jour (19 pages), Note de mise à jour (19 pages), Note de mise à jour (18 pages), Manuel d'instructions (17 pages), Note de mise à jour (17 pages), Instructions de mise à niveau (16 pages), Manuel d'instructions (16 pages), Manuel d'instructions d'installation (16 pages), Note de mise à jour (16 pages), Note de mise à jour (17 pages), Note de mise à jour (17 pages), Note de mise à jour (11 pages)

About this document

If upgrading to firmware 06.02.00-22 requires you to upgrade from 04.xx.xx to

05.xx.xx in the process, there are special considerations. If you are upgrading a

director, see

page 10. If you are upgrading an edge switch, see

edge switch from 04.xx.xx to

A small number of early-shipped Surestore Director FC-64 units may receive one

of the following messages when they upgrade to firmware 05.02.00-13:

This occurs only in certain units with CTP cards. Units with CTP2 cards do not

have this issue.

If you get one of these messages during the upgrade, the firmware upgrade failed,

but the unit continues working with the existing firmware without an interruption

in service. The upgrade process checks for sufficient memory before activating the

new firmware image. The firmware upgrade does not complete without sufficient

memory. Please contact HP Customer Support if you receive this message.

Upgrading firmware on a director from 04.xx.xx to 05.xx.xx

An issue has been identified in release 04.xx.xx if the contents of the nonvolatile

storage (NVRAM) on the active CTP become corrupted. Once the configuration

has been loaded, this corruption is not detected until an IPL/IML, power cycle, or

firmware code load. If the NVRAM in the active CTP has corrupted contents, the

firmware load can cause the configuration to reset to factory defaults, which could

cause a system outage. By using the following procedure to upgrade firmware,

configuration can be preserved and a system outage can be avoided. This issue

was corrected with firmware 05.02.00-13 and later.

Note:

05.xx.xx or later.

To safely upgrade firmware on a director, perform the following:

1. Upgrade HAFM software on the HAFM server/appliance to 07.01.00

"Upgrading firmware on a director from 04.xx.xx to

HAFM—Firmware cannot be loaded due to insufficient

CTP memory.

EWS—File System Error: Insufficient memory for new

firmware version.

Step 4 of the following procedure is not required if you are upgrading from

(minimum).

"Upgrading firmware on an

05.xx.xx" on page 11.

HP StorageWorks HA-Fabric Manager release notes

05.xx.xx" on