HP 316095-B21 - StorageWorks Edge Switch 2/24 Note de mise à jour - Page 9

Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} HP 316095-B21 - StorageWorks Edge Switch 2/24. HP 316095-B21 - StorageWorks Edge Switch 2/24 22 pages. Edge switch release notes
Également pour HP 316095-B21 - StorageWorks Edge Switch 2/24 : Manuel de mise à jour (9 pages), Manuel (41 pages), Manuel (40 pages), Note de mise à jour (32 pages), Note de mise à jour (27 pages), Manuel (26 pages), Note de mise à jour (27 pages), Note de mise à jour (25 pages), Manuel d'instructions d'installation (24 pages), Note de mise à jour (23 pages), Note de mise à jour (23 pages), Note de mise à jour (23 pages), Note de mise à jour (19 pages), Note de mise à jour (19 pages), Note de mise à jour (18 pages), Manuel d'instructions (17 pages), Note de mise à jour (17 pages), Instructions de mise à niveau (16 pages), Manuel d'instructions (16 pages), Manuel d'instructions d'installation (16 pages), Note de mise à jour (16 pages), Note de mise à jour (17 pages), Note de mise à jour (17 pages), Note de mise à jour (11 pages)

Note:

path, not the total number of ISL connections between devices.

Cable Requirements

Note:

Switch 2/32 must be ordered separately.

For cables measuring up to 500 meters (1 Gbps) or 300 meters (2 Gbps), use

multi-mode Fibre Channel cables. For longer cables, use single-mode Fibre

Channel cables.

Multi-mode optical cables are connected to short-wave optical transceiver

modules in a switch. Single-mode optical cables are connected to long-wave

optical transceiver modules in a switch. Multi-mode cables should use 50/125

optical fibers, and single-mode cables typically use 9/125 optical fibers for

distances up to 10 km.

Verify that connectors interfacing with the Edge Switch 2/24 and Edge

Switch 2/32 use LC Duplex connectors with a PC finish. In addition, the

connector at the opposite end of the cable must use either LC or SC type,

depending on the requirements of the connected device.

Edge Switch Release Notes

Hop Count – The Fibre Channel theoretical limit of ISL connections

traversed (hop count) in a single path through a fabric is 7. The maximum

supported hop count in a single path through a fabric is 3. Because this

number is subject to change, contact your HP authorized service

representative for the current hop count supported by a single fabric path.

The hop count is equal to the number of ISL connections traversed in a single

Please note that optical cables for the Edge Switch 2/24 and Edge

Cable Requirements