HP 316095-B21 - StorageWorks Edge Switch 2/24 Note de mise à jour - Page 20

Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} HP 316095-B21 - StorageWorks Edge Switch 2/24. HP 316095-B21 - StorageWorks Edge Switch 2/24 23 pages. Edge switch release notes
Également pour HP 316095-B21 - StorageWorks Edge Switch 2/24 : Manuel de mise à jour (9 pages), Manuel (41 pages), Manuel (40 pages), Note de mise à jour (32 pages), Note de mise à jour (27 pages), Manuel (26 pages), Note de mise à jour (27 pages), Note de mise à jour (25 pages), Manuel d'instructions d'installation (24 pages), Note de mise à jour (23 pages), Note de mise à jour (23 pages), Note de mise à jour (22 pages), Note de mise à jour (19 pages), Note de mise à jour (19 pages), Note de mise à jour (18 pages), Manuel d'instructions (17 pages), Note de mise à jour (17 pages), Instructions de mise à niveau (16 pages), Manuel d'instructions (16 pages), Manuel d'instructions d'installation (16 pages), Note de mise à jour (16 pages), Note de mise à jour (17 pages), Note de mise à jour (17 pages), Note de mise à jour (11 pages)

Issue

Switch Ethernet connection will become inaccessible

if the Access Control List (ACL) contains IPv6 entries,

and the firmware is downgraded to version

09.06.xx or earlier. IPv6 is supported only by firm-

ware version 09.07 xx or later.

If SSL is enabled and an HAFM/EFCM Basic

browser session is open, and the keys are reset us-

ing another switch interface, then the current

browser session will no longer function.

If a server configured to receive syslog messages

has both IPv6 and IPv4 addresses configured, then

syslog messages are not sent to the configured

server when only the IPv6 address of the server is

available.

A Fabric Init error may occur when a two-switch

fabric has only one ISL between them, and the ISL

is blocked and unblocked. When this occurs, the

fabric is not formed.

B-series switches display a Gx port connection as

Loopback when should display a segmented condi-

tion, for M-series Edge Switch 2/24 or McDATA

Sphereon 4500, M4700, or M4400.

Workaround

Before downgrading firmware to a version earlier than

09.07.00, IPv6 addresses must first be removed from

the ACL.

Open a new browser session and login to the switch

again using HAFM/EFCM Basic.

Configure only IPv6 or IPv4 addresses of the server which

is configured to receive syslog messages. Alternatively,

if the server's syslog client allows setting different listen-

ing ports for the IPv6 and IPv4 addresses, then this will

allow using both.

When encountered, this can be corrected by setting one

of the switches offline and then back online. This would

be disruptive to devices connected to the switch that is

set offline, and should be planned for accordingly.

Configure port as G_port and not Gx_port when attach-

ing to B-series.