HP 5120 SI Series Manuel d'installation - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HP 5120 SI Series. HP 5120 SI Series 48 pages. 5120 si switch series
Également pour HP 5120 SI Series : Spécifications (33 pages)
Imprimer la page
Connecting the power cord
WARNING!
Make sure the grounding cable has been correctly connected before powering on the switch.
Use
Table 7
Table 7 Power cord connection methods at a glance
Chassis
5120 16G SI
5120 24G SI
5120 48G SI
5120 8G PoE+ (65W) SI
5120 8G PoE+ (180W) SI
5120 24G PoE+ (370W) SI
Connecting the AC power cord
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Connect one end of the AC power cord to the AC-input power receptacle on the switch.
Figure 18
3.
Connect the other end of the AC power cord to the AC power outlet.
Figure 18 Connecting the AC power cord to the 5120 24G SI switch
Connecting the switch to a –52 to –55 VDC output RPS
This section applies to the 5120 24G PoE+ (370W) SI switch.
To connect these switches to the RPS that provides –52 to –55 VDC output:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Unpack the RPS cable shipped with the RPS, identify the plug for connecting to the switch,
correctly orient the plug with the RPS receptacle on the switch chassis, and insert the plug into
the receptacle (see callout 1 in
The RPS receptacle is foolproof. If you cannot insert the plug into the receptacle, re-orient the
plug rather than use excessive force to push it in.
to identify the power cord connection procedures available for your switch.
uses a 5120 24G SI switch for illustration.
Connection procedure
Connecting the AC power cord
AC-input:
Connecting the AC power cord
Connecting the switch to a –52 to –55 VDC output RPS
RPS input:
Figure
19).
15