AQUATECH Elite Sport Manuel d'instruction - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} AQUATECH Elite Sport. AQUATECH Elite Sport 6 pages. Housing

*If you do notice any amount of water in your Sport

Housing take it apart dry it completely out and

water test again. If the problem persists please

contact AquaTech directly at

You are now ready to enter the water, but always be

conscious of your equipment and please check your

new Sport Housing periodically to make sure no

water has seeped in.

OVERVIEW

Thank you for purchasing your AquaTech Sport

Housing. AquaTech Sport Housings are designed for

shallow water and surface use only. They have been

tested and rated to 10 meters (33 feet) however, a

working depth of 5 meters (15 feet) should not be

exceeded for more than 5 minutes. Our products are

NOT designed for a diving application.

Your new Sport Housing has been water tested,

electrical tested, control tested and is ready for use.

However, please inspect the product before use as

there might have been damage done in shipping.

Also please familiarize yourself with the product

before going in the water.

FEATURES

Front Compression O-ring - seated in the groove

below the front threads. Will seal against the base

of the port when screwed in. Always make sure

this Compression O-ring is properly seated in the

groove before screwing on the port. Do NOT use

O-ring Grease on this O-ring.

Back Main O-ring - seated in the groove between

the main body housing and the Back Plate. The Back

Plate is the clear acrylic piece with the controls for

your camera. Always make sure the Main O-ring

is seated properly in the groove before clamping

down the back plate. Do NOT use O-ring Grease on

this O-ring.

Shutter Release Assembly - this mechanical control

is located on the top right of the Sport Housing

and directly hits the shutter release button on your

camera.

Camera Plate - this part bolts to the bottom of your

camera and slides into the AquaTech Manny Mount

located on the inside of your Sport Housing. The

Camera Plate also can be used to hold your camera

on different Arca Swiss type Quick Release Systems.