AQUATECH EVO III Manuel d'instruction - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} AQUATECH EVO III. AQUATECH EVO III 8 pages. Sport housing
Également pour AQUATECH EVO III : Manuel d'instruction (5 pages)
Imprimer la page
Initial Setup
•
After removing your Sport Housing from the box,
place it face down on a soft level surface.
•
Proceed to unlock the Safety Clips one by one by
pulling the safety latch forward (when the Backplate
is facing up), and pulling the Safety Clip up to
release it from the body of the Sport Housing. Now
repeat the process with Safety Clips two through
four, and remove the Backplate carefully, lifting
the Backplate up and away from the housing.
*IMPORTANT: BE CAREFUL NOT TO DROP YOUR
BACKPLATE WHILE UNLOCKING YOUR CLIPS.
•
Do a quick inspection of the inside of the Sport
Housing to ensure the Camera Plate and Cable
Release are installed and ready for use.
•
Next inspect your Backplate , the main camera
controls are located here. The push button controls
are adjustable to suit the camera by winding out the
black tips on the inside of the Backplate . You can
increase or decrease sensitivity this way. Keeping
the Backplate clean will also help when reviewing
images.
•
To reinstall your Backplate place your Sport Housing
on a flat surface facing down. Place the Backplate
on the Sport Housing making sure to align the
Backplate to each side of the housing using the
Locating Pins, ensuring it sits flush on the Housing.
To secure your Backplate to the Sport Housing,
attach the safety Safety Clip to the hook and firmly
lock. Repeat the process for the remaining Safety
Clips.
•
PRO TIP: When securing your clips, secure your top
left Safety Clip first and then the bottom right Safety
Clip on the opposite side. Then the top right Safety
Clip and finally the bottom left.
Installing your Camera Plate
•
When receiving your AquaTech Sport Housing
remove the Camera Plate from the mount by sliding
the Camera Plate towards you.
•
Double check the Camera Plate is correct and
includes a 1/4"-20 screw. Each Camera Plate has the
camera model it suits engraved on the top side. To
install the Camera Plate on your Sport Housing you
will need a flat head screwdriver.
•
Lineup the top side of the Camera Plate to the
bottom of your camera ensuring the screw hole
opening on the Camera Plate is lined up with the
tripod mount thread under the camera body.
•
Screw in the Camera Plate bolt and tighten it to the
right until you feel some resistance, be careful not to
over tighten the bolt.
Installing the Cable Release
•
Inside the Sport Housing you will find a Cable
Release connected to a PCB board on the left hand
side. Be sure the Cable Release is fully plugged into
the female end on the PCB board. The male end of
the Cable Release will be plugged into the remote
control input on your camera. Each camera has a
different spot for this input, most times you will find
this input on the left hand side of the camera.
•
Ensure the Cable Release is fully plugged into the
camera. This will now enable the electronic shutter
buttons and pistol to activate your camera shutter
4