3Com 10BASE-2 (BNC Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} 3Com 10BASE-2 (BNC. 3Com 10BASE-2 (BNC 6 pages. Unterminated ethernet 10base-2 (bnc) module

Imprimer la page

Module Description

Audience

NTERMINATED

10BASE-2 (BNC)

ODULE

For the LANplex 2500/2016

This module contains eight (8) unterminated Ethernet 10BASE-2 ports that

use BNC connectors. I f a port on this module is at the end of a 10BASE-2

(BNC) segment, you must provide an external 50 Ohm terminator.

When the port is at the end of a segment, using a T connector with a

terminating plug may cause interference with adjacent ports. 3Com

recommends terminating ports with the ITT Pomona Y connector, Model

4896, with a terminating plug on the end, or the ITT Pomona Feed-Thru

Terminator, Model 4119-50. When the port is in the middle of a segment, the

Y connector may be necessary.

Prior to installing the unterminated 10BASE-2 (BNC) module, LANplex

system software revision 7.0.0 or later and LANplex diagnostics software

revision 3.0.2 or later must be installed. A system software revision

supporting this module is available from the 3com BBS, the Internet FTP site

(3Com.ftp.com), or 3Com Forum on Compuserve, or 3Com's Web site

(http://infodeli.3com.com/infodeli/swlib/switch_ﬁles.htm).

Unterminated

Board

Error

For a description of how to conﬁgure this module into your network, see

the LANplex documentation set.

This guide is intended for trained technical personnel only.

THERNET

NSTALLATION

UIDE

Port Status

Active

Error