AQUATECH RAPID/X6 Manuel d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AQUATECH RAPID/X6. AQUATECH RAPID/X6 2 pages. Plumber's condensed
Imprimer la page
1.
Cold Water supply outlet
(G 3/4" female thread)
2..
Hot Water Outlet
(G 3/4" female thread)
3.
Condensing drainage Elbow*
4.
P&T Relief Valve*
(G 1/2" female _ ) (850kPa)
5.
Electrical Cable
6.
Tempering Valve
(high performance recommended)
7.
Expansion Control Valve (ECV)
(if required by council 700kPa)
8.
Pressure Reduction Valve
(500kPa)
9.
Non-return/Isolation Valve
10. Isolation Switch
(Hard wired into 10 Amp circuit)
* Supplied with system
4. CONDESATION DRAINAGE
Condensate
drainage
elbow
Dish
Hand
screws
Tighten
Loosen
3. PLUMBING CONNECTIONS
10
6. TURNING THE UNIT ON
1.
Remove Stainless Steel cover by simply loosening hand screws.
2.
Unlock the screen by pressing the POWER button once.
3.
Press and hold the POWER button for 3 seconds until the SUN symbol flashes.
4.
Return screen cover back onto unit after setting clock
To drain
To drain
To house
Cold water
8
9
To drain
5. BLEEDING THE SYSTEM
Ensure at least one hot water tap is open inside the
property. While the system begins filling with water,
you will hear air being expelled from the open hot
water tap. This ensures that no air pockets remain.
Once water begins running out of the hot water
tap, the system is completely bled and you can then
turn the tap off.
5
3
2
4
6
7
1
SYSTEM MUST
BE LEVEL
pg.2