HP ProCurve Series Manuel d'installation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HP ProCurve Series. HP ProCurve Series 18 pages. High-speed transceivers
Également pour HP ProCurve Series : Lisez-moi d'abord (8 pages)
Imprimer la page
xcvrs_3-2002.fm Page 4 Tuesday, April 2, 2002 3:23 PM
3. Slide the transceiver firmly into the transceiver slot as far as it will go.
The transceiver will "snap" into place, and the transceiver's faceplate
should touch the face of the switch or module. The following illustration
shows the transceiver being installed in an HP Procurve Switch Gigabit
Transceiver GL Module.
4. Using the flat-bladed or Torx T-10 screwdriver, tighten the retaining
screws on the transceiver until they are secure, but be careful that you
do not overtighten the screws.
5. If the transceiver is installed in a module and you have not yet installed
the module into the switch, reinstall the module into the switch and
make sure the switch is powered on, or if the transceiver is installed
directly into a switch, reset the switch, if necessary, to initialize the
transceivers. Please see the Installation Notes on page 2 for information
about initializing the transceivers in different HP Procurve networking
devices.
Connect Network Cables to the Transceiver Port
The network cables identified in the table on the next page should be used
with the HP Procurve High-Speed Transceivers.
When power is applied to this transceiver
and an active network cable is connected to
the transceiver port, the Link LED for the
port should be ON.
If the LED is off, see "Troubleshooting", on
the page 11.
4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
slide the transceiver into the
slot until it snaps into place
Link LED