HP StorageWorks 1500cs - Modular Smart Array Instructions de remplacement - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions de remplacement pour {nom_de_la_catégorie} HP StorageWorks 1500cs - Modular Smart Array. HP StorageWorks 1500cs - Modular Smart Array 5 pages. Storageworks modular smart array
Également pour HP StorageWorks 1500cs - Modular Smart Array : Manuel d'administration (40 pages), Note de mise à jour (13 pages), Manuel de démarrage rapide (7 pages), Note de mise à jour (5 pages), Instructions de remplacement (4 pages), Instructions de remplacement (2 pages), Manuel (16 pages), Installation (4 pages)

Imprimer la page
HP StorageWorks 1500cs - Modular Smart Array Instructions de remplacement
Remove the MSA from the rack
1.
Remove the decorative bezel from the front of the MSA by grasping
the outside edges and pulling with sufficient force to disengage
the retaining clips.
2.
Loosen the thumbscrews securing the MSA to the front of the rack,
and then slide the MSA out of and away from the rack.

Installing the replacement chassis

Record the serial numbers of the two chassis
IMPORTANT:
Depending on the MSA model and firmware version, the serial
number of the original chassis may automatically be transferred
to the replacement chassis. For continued service and support
from HP authorized service personnel, the serial number of the
original chassis must also be physically recorded on the label of
the replacement chassis.
The product label is located on the side of the MSA chassis.
Install the MSA in the rack
1.
Slide the MSA into the rack, and then secure the MSA to the front
of the rack, using the thumbscrews on the front of the MSA.
2.
Attach the decorative bezel on the front of the MSA by aligning
the pins and retaining clips on the back of bezel with the
corresponding locations on the front of the chassis. Then, with even
pressure, push firmly on the bezel until the retaining clips engage.
15642

Install the controllers

1.
Press the controller thumb latch and rotate the latch handle out.
2.
Slide the controller into the chassis and then push firmly to ensure
a good seat.
3.
Rotate the latch handle inward, pressing until it is flush against
the front panel.
4.
Install the other controller or blank.

Install the power supply modules

1.
Slide the module into the chassis power supply slot until the latch
clicks into place.
15641
2.
Install the other module.
Page 3
2
15649
1
15493
15646