Aquatek ATCBF Series Manuel d'utilisation et d'entretien - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Aquatek ATCBF Series. Aquatek ATCBF Series 19 pages. Arsenic systems

Imprimer la page

Problem

Err - 1001 = Control

unable to sense motor

movement

Err - 1002 = Control

valve motor ran too

short and was unable

to find the next cycle

position and stalled

Err - 1003 = Control

valve motor ran too

long and was unable

to find the next cycle

position

Err - 1004 = Control

valve motor ran too

long and timed out

trying to reach home

position

Possible Cause

Motor not inserted full to engage pin-

ion, motor wires broken or disconnect-

Circuit Board not properly snapped

into drive bracket

Missing reduction gears

Foreign material is lodged in control

valve

Mechanical binding

Main Drive Gear too tight

Improper voltage being delivered to

Circuit Board

Motor failure during a regeneration

Foreign matter built up on Piston and

Seal and Spacer Stack Assemblies cre-

ating friction and drag enough to time

out Motor

Drive Bracket not snapped in properly

and out enough that reduction gears

and drive gear do not interface

Drive Bracket not snapped in properly

and out enough that reduction gears

and drive gear do not interface

UNITED WATER INC.

AtCBF-AS-S

quAtek

Solution

Disconnect power, make sure motor is

fully engaged, check for broken wires,

make sure two pin connector on motor

is connected to the two pin connection

on the Circuit Board labeled MOTOR.

Press NEXT and REGEN buttons at the

same time for 3 seconds to resynchro-

nize software with piston.

Properly snap Circuit Board into drive

bracket and then Press NEXT and

REGEN buttons at the same time for 3

seconds to resynchronize software with

piston.

Replace missing gears

Open up Control Valve and pull out

piston assembly and Seal and Spacer

Stack Assembly for inspection. Press

NEXT and REGEN buttons at the same

time for 3 seconds to resynchronize

software with piston.

Check Piston and Seal and Spac-

er Stack Assembly, check Reduction

Gears, check Drive Bracket and Main

Drive Gear Interface. Press NEXT and

REGEN buttons at the same time for 3

seconds to resynchronize software with

piston.

Loosen Main Drive Gear. Press NEXT and

REGEN buttons at the same time for 3

seconds to resynchronize software with

piston.

Verify that proper voltage is being sup-

plied. Press NEXT and REGEN buttons at

the same time for 3 seconds to resyn-

chronize software with piston.

Check motor connections then Press

NEXT and REGEN buttons at the same

time for 3 seconds to resynchronize

software with piston.

Replace Piston and Seal and Spac-

er Stack Assemblies. Press NEXT and

REGEN buttons at the same time for 3

seconds to resynchronize software with

piston.

Snap Drive Bracket in properly then

Press NEXT and REGEN buttons at the

same time for 3 seconds to resynchro-

nize software with piston

Snap Drive Bracket in properly then

Press NEXT and REGEN buttons at the

same time for 3 seconds to resynchro-

nize software with piston.

erieS

Ser

uide