HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM Manuel de référence - Page 21

Parcourez en ligne ou téléchargez le pdf Manuel de référence pour {nom_de_la_catégorie} HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 46 pages. 1u rackmount tape enclosure
Également pour HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM : Instructions d'installation (2 pages), Manuel d'instructions d'installation (20 pages), Manuel d'installation (14 pages), Note de mise à jour (14 pages), Instructions d'installation (2 pages)

Slide the component rails toward the rear of the enclosure 2 until they lock into place.

Figure 15

Attaching the component rails to the enclosure

NOTE:

To remove the component rail, pull out the spring-loaded tab

slide it forward

CAUTION:

If you are returning the 1U Rackmount Tape Enclosure for service, be sure to remove

and save the component rails.

Installing the rack rails

Installation procedures vary depending on the rack type. The rails are shipped ready for installation

in racks with round or square holes. If the rails are to be installed in racks with 10-32 threaded

holes, the mounting pins must first be removed. Refer to one of the following sections for installation

instructions for your rack.

• "Installation in racks with round or square

• "Installation in racks with 10-32 threaded

NOTE:

The ends of the rack rails are marked FRONT and REAR for proper orientation.

15118

holes" on page 21

holes" on page 24

1U Rackmount Tape Enclosure Reference Guide

on the side of the rail and