HP XP20000/XP24000 Manuel de configuration - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} HP XP20000/XP24000. HP XP20000/XP24000 40 pages. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Également pour HP XP20000/XP24000 : Note de mise à jour (13 pages), Manuel d'intégration (29 pages), Note de mise à jour (4 pages), Manuel de l'administrateur (50 pages), Manuel de configuration (42 pages), Manuel de configuration (40 pages), Manuel de configuration (36 pages), Manuel de configuration (36 pages), Manuel de configuration (30 pages), Manuel de configuration (36 pages), Note de mise à jour (5 pages), Manuel de configuration (46 pages), Manuel de configuration (46 pages), Manuel de référence (46 pages), Manuel de configuration (40 pages), Manuel de configuration (44 pages), Manuel de configuration (38 pages), Manuel de configuration (34 pages), Manuel de configuration (30 pages), Manuel de configuration (30 pages)

Configuring disk array devices

Partitioning the devices

Creating the file systems

Creating the mount directories

Creating the mount table

Verifying file system operation

Installing and configuring the disk array

The HP service representative performs these tasks:

Assembling hardware and installing software

Loading the microcode updates

Installing and formatting devices

After these tasks are finished, you will use XP Remote Web Console, XP Command View Advanced

Edition Software, or XP Array Manager to complete the remaining tasks listed below. If you do not

have these programs, your HP service representative can perform these tasks for you.

After the disk array is installed, you must set the host mode for each host group that is configured on

a disk array port to match the host OS. Set the host mode using LUN Manager in XP Remote Web

Console (shown) or XP Command View Advanced Edition Software. If these are not available, the

HP service representative can set the host mode using the SVP. The host mode setting for Linux is 00.

CAUTION:

The correct host mode must be set for all new installations (newly connected ports) to Linux hosts. Do

not select a mode other than 00 for Linux. Changing a host mode after the host has been connected

is disruptive and requires the server to be rebooted.

When a new host group is added, additional host group modes (options) may be configured. The

storage administrator must verify if an additional host group mode is required for the host group.

Installing and configuring Linux for the XP disk array