HP XP20000/XP24000 Manuel de configuration - Page 31

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} HP XP20000/XP24000. HP XP20000/XP24000 40 pages. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Également pour HP XP20000/XP24000 : Note de mise à jour (13 pages), Manuel d'intégration (29 pages), Note de mise à jour (4 pages), Manuel de l'administrateur (50 pages), Manuel de configuration (42 pages), Manuel de configuration (40 pages), Manuel de configuration (36 pages), Manuel de configuration (36 pages), Manuel de configuration (30 pages), Manuel de configuration (36 pages), Note de mise à jour (5 pages), Manuel de configuration (46 pages), Manuel de configuration (46 pages), Manuel de référence (46 pages), Manuel de configuration (40 pages), Manuel de configuration (44 pages), Manuel de configuration (38 pages), Manuel de configuration (34 pages), Manuel de configuration (30 pages), Manuel de configuration (30 pages)

C HP Cluster Gateway deployments

The HP Cluster Gateway and HP Scalable NAS software both use the HP PolyServe software as their

underlying clustering technology and both have very similar requirements for the XP disk array. They

have both been tested with the XP disk arrays and this appendix details configuration requirements

specific to XP deployments using HP PolyServe Software on Linux.

For details on installing and configuring the HP PolyServe software, see the HP StorageWorks Scalable

NAS File Serving Software installation guide.

For any XP specific requirements, see the Enterprise Scalable NAS Products and Solutions Compatibility

Matrix, which you can download from

SupportManual/c01336151/c01336151.pdf.

NOTE:

MxS3.5.1P1 was released to address a specific SCSI code page change in the XP24000.

HP recommends using the HBA drivers specifically supported by the XP array. Other drivers will work,

but may not produce optimal results during failure or failover situations.

On the HP Cluster Gateway and, typically, on HP Scalable NAS deployments, the HBA driver is

loaded by the HP PolyServe software from the /etc/opt/hpcfs/fc_pcitable file. Set any driver

loading options, such as configuring the Qlogic failover driver, in this file.

Configure the HP Cluster Gateway and HP Scalable NAS software running on SuSE SLES9 and Red

Hat Enterprise Linux Version 4 to use the Qlogic failover driver for their host based multipath I/O

software.

Configure the HP Cluster Gateway and HP Scalable NAS software running on SuSE SLES10 and Red

Hat Enterprise Linux Version 5 to use Device Mapper for their host based multipath I/O software.

To work correctly with the HP PolyServe clustering technology, all LUNs on the disk array need to be

presented identically to all nodes in the cluster. When using the LUNs for a membership partition,

create a Linux partition table on the LUNs using a tool such as fdisk. If the LUNs are being used for

dynamic volumes or file systems, you do not need to install a partition table on them.

http://bizsupport2.austin.hp.com/bc/docs/support/

XP Disk Array Configuration Guide for Linux