HP XP20000/XP24000 Manuel de configuration - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} HP XP20000/XP24000. HP XP20000/XP24000 36 pages. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Également pour HP XP20000/XP24000 : Note de mise à jour (13 pages), Manuel d'intégration (29 pages), Note de mise à jour (4 pages), Manuel de l'administrateur (50 pages), Manuel de configuration (42 pages), Manuel de configuration (40 pages), Manuel de configuration (40 pages), Manuel de configuration (36 pages), Manuel de configuration (36 pages), Manuel de configuration (30 pages), Note de mise à jour (5 pages), Manuel de configuration (46 pages), Manuel de configuration (46 pages), Manuel de référence (46 pages), Manuel de configuration (40 pages), Manuel de configuration (44 pages), Manuel de configuration (38 pages), Manuel de configuration (34 pages), Manuel de configuration (30 pages), Manuel de configuration (30 pages)

HP XP20000/XP24000 Manuel de configuration
Heterogeneous operating systems may share an XP array port if you use Secure Manager and set
the appropriate host group and mode. All others must connect to a dedicated XP array port.
Use Secure Manager for LUN isolation when multiple hosts connect through a shared array port.
Secure Manager provides LUN security by allowing you to restrict which LUNs each host can access.
QLogic and Emulex FCAs must be in separate zones (a QLogic zone and an Emulex zone)
whether the FCAs are in the same or separate servers.
If booting over the SAN, within a server, the booting FCAs must be from the same vendor. Addi-
tional data storage FCAs can be from a different vendor.
Table 5 Fabric zoning and LUN security
Environment
Standalone SAN
(non-clustered)
Clustered SAN
Multi-Cluster SAN
If you plan to use clustering, install and configure the clustering software on the servers. Clustering
is the organization of multiple servers into groups. Within a cluster, each server is a node. Multiple
clusters compose a multi-cluster environment. The following example shows a multi-cluster environ-
ment with three clusters, each containing two nodes. The nodes share access to the disk array.
Figure 3 Multi-cluster environment
.

Connecting the disk array

The HP service representative connects the disk array to the host by:
1.
Verifying operational status of the disk array channel adapters, LDEVs, and paths.
2.
Connecting the Fibre Channel cables between the disk array and the fabric switch or host.
3.
Verifying the ready status of the disk array and peripherals.
14
Installing and configuring Windows for the XP disk array
OS mix
homogeneous (a
single OS type
Not required
present in the SAN)
heterogeneous (more
than one OS type
Required
present in the SAN)
Fabric zoning
LUN security
Must be used when
multiple hosts or
cluster nodes connect
through a shared port