HP XP20000/XP24000 Manuel de configuration - Page 23

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} HP XP20000/XP24000. HP XP20000/XP24000 46 pages. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Également pour HP XP20000/XP24000 : Note de mise à jour (13 pages), Manuel d'intégration (29 pages), Note de mise à jour (4 pages), Manuel de l'administrateur (50 pages), Manuel de configuration (42 pages), Manuel de configuration (40 pages), Manuel de configuration (40 pages), Manuel de configuration (36 pages), Manuel de configuration (36 pages), Manuel de configuration (30 pages), Manuel de configuration (36 pages), Note de mise à jour (5 pages), Manuel de configuration (46 pages), Manuel de référence (46 pages), Manuel de configuration (40 pages), Manuel de configuration (44 pages), Manuel de configuration (38 pages), Manuel de configuration (34 pages), Manuel de configuration (30 pages), Manuel de configuration (30 pages)

CAUTION:

To ensure that the system can boot properly even if you make a mistake in the driver configuration

file, add the new paths at the end of the file. (This ensures that the system boot entries higher up in

the file will execute first.)

Pre-configure additional LUNs (not yet made available) to avoid unnecessary reboots. Refer to

and configuring the

Verifying host recognition of disk array devices

Verify that the host recognizes the disk array devices as follows:

Use format to display the device information.

Check the list of disks to verify the host recognizes all disk array devices. If any devices are

missing or if no array devices are shown, check the following:

SAN (zoning configuration and cables)

Disk array path configuration (FCA HBA WWNs, host group 09 and host group mode 7 set,

and LUNs defined for the correct array ports)

Verify that host group 09 and host group mode 7 are set. Although host group mode 7 is

required only with the Sun SAN driver stack, always setting it is a best practice.

Host FCA configuration (WWN information, driver instance, target and LUN assignment,

and /var/adm/messages)

If you are using the Sun SAN driver and XP LUNs were not present when the configuration

was done, you may need to reset each FCA if no LUNs are visible. The following example

shows the commands to detect the FC-fabric attached FCAs (c3, c5) and resetting them.

# cfgadm -l | grep fc-fabric

# luxadm -e forcelip /dev/cfg/c3

# luxadm -e forcelip /dev/cfg/c5

Disk arrays are configured using the same procedure for configuring any new disk on the host. This

typically includes the following procedures:

Labeling and partitioning the devices

Creating the file systems

Creating the mount directories

TIP:

Creating scripts to configure all devices at once may save you considerable time.

FCAs" on page 15 for individual driver requirements.

fc-fabric

connected

configured

connected

configured

XP Disk Array Configuration Guide: Solaris

"Installing

unknown