Diamond Products CC1600 Manuel de l'opérateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Diamond Products CC1600. Diamond Products CC1600 16 pages. Wall saw

Imprimer la page

GENERAL SAW SAFETY

• Never leave the saw unattended while running.

• Do not exceed the rated pressure of hydraulic components. If you are unsure, contact

the manufacturer or Diamond Products.

• Ensure that the track is securely mounted to the wall, with the track stop bolts in

place, before starting the saw. (Track assemblies with stiffener only)

• Verify that the saw is operating properly before cutting. The track rollers must be

adjusted properly and rotating freely. The motor must be connected to the power unit

to rotate the blade in a clockwise direction (facing the saw from the blade). The blade

must be properly mounted in the flanges. The guard must be in place and set to

protect the operator. All saw functions should be checked before mounting the blade.

• Set the blade guard to give maximum protection for the operator. Inspect the blade

guard frequently for damage, cracks, and wear.

• Never operate the saw without sufficient water flow to cool the blade and flush out

cutting debris.

• Always disconnect the power unit before servicing the saw.

• Never try to connect or disconnect the power unit while the power unit is running

and/or the hoses are under pressure.

• Before cutting, be sure that there are no electric, water, or gas lines in the area you

are working. Do not saw if you are unsure of the presence of utility lines in the work

area.

• The cut out section can be very heavy. (For example, a 3' x 7' door cut from a 12"

thick wall will weigh over 3000 lb.) Be sure that the slab is properly secured before

making the final cut.

CUTTING/WORK AREA SAFETY

• Never operate the saw in any application or job where you are not properly trained or

supervised.

• Operate only in well-ventilated areas.

• Place barricades or tape to block off the work area on both sides of the wall. Keep

bystanders, animals, and unnecessary equipment out the work area.

• Do not operate the saw near combustible material or fumes. Sparks occur during

sawing that may cause a fire or explosion.

FAILURE TO COMPLY WITH THE PRECEDING WARNINGS COULD

RESULT IN SERIOUS BODILY INJURY.