Diamond Products HDS60-8 Manuel de l'opérateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Diamond Products HDS60-8. Diamond Products HDS60-8 19 pages. Concrete saw
Imprimer la page
Technical Information
Weight (without blade) -------------------------- 29.8 lbs. / 12.5 kg
Width ------------------------------------------------ 10-1/4 in. / 260 mm
Height (without the blade) --------------------- 19 in.. / 483 mm
Length (without the blade) --------------------- 26 in. / 660 mm
Power Requirement ----------------------------- Hydraulic
Maximum flow ------------------------------------ 8 GPM / 30 l/min.
Maximum pressure ------------------------------ 2500 PSI / 172.5 bar
Maximum blade diameter ---------------------- 20 in. / 510 mm
Maximum cutting depth with 16" blade ----- 12 in. / 300 mm
Maximum cutting depth with 20" blade ----- 16 in / 407 mm
Cooling of blade ---------------------------------- Water cooled only (no dry cutting allowed)
Troubleshooting
Saw will not start turning ----------- Confirm power supply is on and hoses are connected correctly.
Sparks coming from the side
of the blade while turning ---------- Inadequate water flow or pressure, check water lines/water supply.
Blade turning too slow -------------- Inadequate hydraulic flow, check power supply.
Blade loose ---------------------------- Re-set guide bearing cover
Gearbox is hot ------------------------ Not enough oil in gearbox.
On/Off handle sticking ------------- Broken plunger o-ring.
Hydraulic oil leak -------------------- Damaged or loose hydraulic fittings.
Accumulation of slurry preventing the saw from turning, clean drive
wheels.
Seized blade guide rollers, replace.
Clogged water injection plate.
Seized blade guide rollers.
Too much oil in gearbox.
Water in oil.
Blocked case vent.
Bent plunger rod.