Diamond Tech Power Miter II Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Diamond Tech Power Miter II. Diamond Tech Power Miter II 8 pages. Chop saw

Imprimer la page

Contents

Your Power Miter II

has been shipped fully assembled. Carefully remove

™

saw and accessories from the packaging.

1- Power Miter II Saw Body

2- Oil Dispenser

3- 1/2 ounce of oil

4- Hex Wrenches

Initial Setup

a. Inspect and adjust Power Miter II Chop Saw.

1) Place chop saw on a firm level work surface. Do not plug

saw in to an electrical outlet at this point.

2) Inspect saw for any damages that may have occurred

during shipping.

3) The blade teeth should be pointing downward at the front

of the saw. If necessary tighten the blade retaining nut at

this time.

4) Occasionally the path of the blade will shift out of alignment

during shipping. Test alignment with miter/angle guide:

1. Unplug saw from the outlet.

2. Loosen the miter lock bolt. (Fig. 1)

2. With the miter/angle guide set at 0° pull the blade

handle down as far as possible.

3. If the saw falls perfectly into the gap (Fig. 2) of the

fence return the blade to the top position.

4. Turn the miter/angle guide to 45° and pull the

blade handle down as far as possible.

5. If the blade still falls perfectly into the gap,

the saw is adjusted properly. If during either test the blade

hits the fence, continue with step 6.

6. Using an adjustable wrench loosen the

blade adjustment screws (Fig. 2) located under the motor

on the back of the saw.

7. With the miter/angle guide set at 0°, grasp the handle

and move the blade arm either left or right until the

blade clears the fence. Repeat this with the miter/

angle guide set at 45°.

8. After the blade has been adjusted to clear the fence,

retighten the blade adjustment screws.

B. Lubrication

1) Blade drive shafts should be lubricated daily before use.

To lubricate blade drive shafts, locate the two lube ports

(oil ports) at the top of the saw near the handle (Fig. 4).

2) Using the provided oil and oil dispenser, add 2-3 drops of

oil to each port before use (Fig. 5).

C. Material Clamping and Supporting

1) Long pieces need extra supports. The supports should be placed

along the work piece so the work piece does not sag. Your hand

holding the work piece should be positioned 4" or more from the

blade path. The support should let the work piece lie flat on the

base and work able during the cutting operation.

Page 2 -

Power Miter ii oPerations Manual

Fig.1

Lock Bolt

Angle Guide

Fig.2

Blade

Fence

Fig.3

Miter/Angle Guide

Blade Adjustment

Screws

Fig.4

Lubricating

Ports

Fig.5

Oil Can