Diamond Vantage TS400 Manuel du propriétaire - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Diamond Vantage TS400. Diamond Vantage TS400 20 pages.

Imprimer la page

Unplug the tile saw before installing a blade.

Carefully raise the cutting head to its highest

position and secure it into place by tightening the

cutting head adjustment knob located to the right

of the power switch at the front of the saw. Use

the provided Allen wrench when tightening the

cutting head adjustment knob.

Raise the blade guard to the highest position and

tighten the blade guard adjustment knob.

Remove the blade shaft nut and outer flange.

Place the blade onto the shaft making sure the

directional arrow on the blade is pointing

counter-clockwise.

After making sure that the blade is firmly placed

against the inner flange, secure it into place

with the outer flange and blade shaft nut. Make

certain the nut is firmly tightened with the wrench

provided, but do not over tighten!

Lower the blade guard and tighten the adjustment

knob with the provided Allen wrench.

Slightly loosen the cutting head adjustment knob

and lower the cutting head to its lowest position,

and then tighten the adjustment knob firmly to

hold the cutting head in place.

If blade needs to be removed, please use two

wrenches provided and follow the next steps:

a. Make sure to disconnect the saw from

electrical outlet.

b. Gently raise the blade guard to the

highest point.

c. Hold the saw shaft with one wrench

d. Hold the shaft nut with other wrench

e. Hold the wrench on the shaft and gently

untighten the nut using other wrench.

f. Remove the nut and outer flange and blade.

If nut is overtightened, DO NOT FORCE TO

UNTIGHTEN. Use a mallet to gently tab the top

of the wrench holding the nut to untighten.

VI. TS400: BLADE INSTALLATION

• 8 • diamondvantage.com

WARNING!

Place the blade to cut completely through the

material. Failing to do so may allow the saw to

grab the material being cut and cause it to shoot

out leading to severe injuries.

Figure 1

Please use two wrenches when you remove the blade.