Diamondback 180 Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Diamondback 180. Diamondback 180 2 pages. For toyota tacoma 2005; toyota tacoma 2006; toyota tacoma 2007; toyota tacoma 2008; toyota tacoma 2009; toyota tacoma 2010; toyota tacoma 2011; toyota tacoma 2012; toyota tacoma 2013; toyota tacoma 2014; toyota tacoma 2015; toyota tacoma 2016; toyota taco
Également pour Diamondback 180 : Manuel d'installation (2 pages), Manuel d'installation (2 pages), Manuel d'installation (2 pages)

Imprimer la page

(800) 935-4002 | DIAMONDBACKCOVERS.COM

INSTALLATION GUIDE

60 minutes

Normal Install Time

PARTS INCLUDED:

180 Cover

TOOLS REQUIRED:

3/8 " Nut

Drill

Driver

PREPARE THE CARGO BED & MOUNT THE COVER

Attach the angle iron to the bulkhead, just below

the taper and centered side to side, using a drill,

3/8" nut driver bit, and five self-drilling screws.

Installing the angle iron is easiest if

you pre-drill it using the screws.

If you are also installing a Cross Bin, do so now. Refer to page 2

of the Cross Bin Installation Guide for details.

Close the tailgate. Place the cover

onto the cargo bed so that the

weatherstrip along the angle piece

welded under the rear of the

cover is firmly compressed

against the inside edge

of the tailgate.

Center the cover

side to side.

Keep an eye out for these icons:

Ratchet

Wrench

9/16" Socket

7/16" Socket

IMPORTANT!

Important installation information

Gas Springs (4)

Angle Iron

PRE INSTALLATION NOTES:

If your truck has bed rail caps, you should affix the included

bulkhead prep kit prior to installing the DiamondBack 180.

Refer to the Bulkhead Prep Kit Installation Guide for details.

1/8" Hex Key

You'll want a second person to help with this installation.

Attach the nose of the T panel to the

angle iron using the G-913 clamps.

Tighten the clamps with a 9/16"

socket.

Attach the cross member of the T

panel to the bed rails using two G-99

clamps at each end. Tighten.

Verify that the cover remains centered side to side

and its rear weatherstrip remains compressed

against the tailgate.

2016 UP NISSAN TITANS

Helpful Hints

Tips to assist installation

G-99 Clamps (4)

1/4" Self-Drilling

G-913 Clamps (2)

Screws (5)

CONTINUED ON REVERSE →

CVR-180.5