Diamondback 58477 Manuel du propriétaire et consignes de sécurité - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et consignes de sécurité pour {nom_de_la_catégorie} Diamondback 58477. Diamondback 58477 8 pages. Tile saw stand
Imprimer la page
Mounting Instructions
Mounting 10" Saw to Stand
WARNING! TO PREVENT SERIOUS
INJURY: Turn the Power Switch of the tile
saw to its "OFF" position, remove its key,
and unplug the tool from its electrical
outlet before mounting to stand.
1.
Lock the Toggle Table Stop by
pulling up on it and turning it until
the slot in the center of the Stop
is horizontal (left to right).
2.
Pull the Table to the front of the Frame.
From under the right side of the Table,
align the hole in the rail with the pin
in the Table Lock Lever. Push the
pin into the rail, locking the Table.
Power Switch
& Key
Page 4
For technical questions, please call 1-888-866-5797.
3.
With assistance, place Saw on Stand.
Align the holes on the Water Tray
Frame with the holes on the Stand.
4.
Secure Saw to Stand with two
Washers M8 (3) and two
Bolts M8x20 (4), tighten Bolts securely.
WARNING! TO PREVENT SERIOUS
INJURY: If the Saw does not mount
securely and completely to this Stand,
do not use it with this Stand.
Table
Lock
Lever
Toggle
Table
Stop
Washer
M8 (3)
Bolt
M8 x 2 0 (4)
Item 58477