Panasonic RQTV0097-2P Manuel d'utilisation - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Panasonic RQTV0097-2P. Panasonic RQTV0097-2P 24 pages. Cd stereo system
Imprimer la page
Specifi cations
AMPLIFIER SECTION
FTC OUTPUT POWER both channel driven
simultaneously
10% Total harmonic distortion
60 Hz to 3 kHz
(Low channel)
SC-PM53
SC-PM533
3 kHz to 16 kHz
SC-PM53
(High channel)
SC-PM533
Total Bi-Amp power
SC-PM53
SC-PM533
RMS OUTPUT POWER both channel driven
simultaneously
10% total harmonic distortion
1 kHz
(Low channel)
SC-PM53
SC-PM533
8 kHz
(High channel)
SC-PM53
SC-PM533
Total Bi-Amp power
SC-PM53
SC-PM533
Input Impedance
Music port
Output Impedance
Headphone
Phone jack
Terminal
Music port input jack
Terminal
FM TUNER SECTION
Frequency range
87.9 MHz to 107.9 MHz (200 kHz steps)
87.5 MHz to 108.0 MHz (100 kHz steps)
Sensitivity
S/N 26 dB
Antenna terminals
Preset station
AM TUNER SECTION
520 kHz to 1710 kHz (10 kHz steps)
Frequency range
Sensitivity
S/N 20 dB (at 1000 kHz)
CASSETTE DECK SECTION
Track system
Heads
Record/playback
Erasure
Motor
Recording system
Erase system
Tape speed
Overall frequency response (+3, –6 dB at DECK OUT)
NORMAL
S/N RATIO
Wow and fl utter
Fast-forward and rewind time
Approx. 120 seconds with C-60 cassette tape
Maintenance
If the surfaces are dirty
If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this
unit.
• Before using chemically treated cloth, read the instructions
that came with the cloth carefully.
For a cleaner, crisper sound
For a cleaner, crisper sound
Clean the heads regularly to assure good quality playback
and recording.
Use a cleaning tape (not included).
CD SECTION
Disc played [8 cm (3") or 12 cm (5")]
40 W per channel (6 Ω)
Sampling frequency
38 W per channel (6 Ω)
39 W per channel (6 Ω)
Bit rate
36 W per channel (6 Ω)
79 W per channel
Decoding
74 W per channel
Pick up
Audio output (Disc)
45 W per channel (6 Ω)
43 W per channel (6 Ω)
Frequency response
Wow and fl utter
45 W per channel (6 Ω)
Digital fi lter
42 W per channel (6 Ω)
D/A converter
90 W per channel
85 W per channel
SPEAKER SECTION
Type
250 mV 12 kΩ
Speaker(s)
16 Ω to 32 Ω
Impedance
Stereo, 3.5 mm (
1
/
")
Input power (IEC)
8
Stereo, 3.5 mm (
1
/
")
8
Output sound pressure
Frequency range
Dimensions (W x H x D)
0.3 µV (IHF)
0.2 µV
Mass
75 Ω (unbalanced)
GENERAL
FM 15 stations
AM 15 stations
Power supply
Power consumption
Dimensions (W x H x D)
Mass
900 µV/m
Operating temperature range
Operating humidity range
4-track, 2-channel
Solid permalloy head
Double gap ferrite head
DC servo motor
1. Specifi cations are subject to change without notice.
AC bias 100 kHz
AC erase 100 kHz
2. Total harmonic distortion is measured by the digital spectrum
4.8 cm/s (1
7
/
ips)
8
3. The labels "HIGH" and "LOW" on the rear or the speakers refer to
35 Hz to 14 kHz
54 dB (A weighted)
0.08% (WRMS)
1
2
3
(1) CD-Audio (CD-DA)
(2) CD-R/RW (CD-DA, MP3, WMA formatted disc)
(3) MP3/WMA
CD-DA
MP3/WMA
MP3/WMA
Wavelength
Beam source
Laser power
Number of channels
Woofer
Tweeter
HIGH
LOW
Crossover over frequency
+5°C to +35°C (+41°F to +95°F)
5% to 90% RH (no condensation)
Power consumption in standby mode 0.4 W
Note
Mass and dimensions are approximate.
analyzer.
High frequency and Low frequency.
When moving the unit
Remove all discs.
Press [POWER y/I] to turn the unit off.
Disconnect the AC power supply cord.
44.1 kHz
32 kHz, 44.1 kHz, 48 kHz
32 kbps to 384 kbps
16/20/24 bit linear
785 nm
Semiconductor laser
CLASS 1
2-Channel
20 Hz to 20 kHz (+1dB, -2 dB)
Below measurable limit
8 fs
MASH (1 bit DAC)
2 way, 2 speaker system
10cm (4˝) cone type (6 Ω)
6 cm (2
3
/
˝) cone type (6 Ω)
8
6 Ω
90 W (Max)
90 W (Max)
80 dB/W (1.0 m)
2.2 kHz
45 Hz to 35 kHz (-16 dB)
50 Hz to 31 kHz (-10 dB)
144 mm x 249 mm x 200 mm
(5
11
/
˝ x 9
13
/
˝ x 7
7
/
˝)
16
16
8
1.9 kg (4.2 lb.)
AC 120 V, 60 Hz
140 W
175 mm x 249 mm x 355 mm
(6
7
/
˝ x 9
13
/
˝ x 13
63
/
˝)
8
16
64
5.4 kg (11.9 lb.)
15