Panasonic SA-AK28 Manuel d'utilisation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Panasonic SA-AK28. Panasonic SA-AK28 32 pages. Cd stereo system model no. sc-ak28; sc-ak18

Imprimer la page

Listening to radio broadcasts

Press [TUNER, BAND] to select band.

The unit will come on automatically.

Every time you press the button: FM

Press [L L L L L , TUNE MODE] to select "PRESET" or

"MANUAL".

Every time you press the button: MANUAL

PRESET:

For preset stations

MANUAL: For non-preset stations

Press [TUNE/TIME ADJ (3) or (4)] to select the

desired broadcast.

"STEREO" lights when an FM stereo broadcast is being received.

"TUNED" lights when you precisely tune in a broadcast station.

Adjust the volume level.

Auto tuning

Auto tuning is an easy way to tune in non-preset stations in the

manual mode.

Hold down either [TUNE/TIME ADJ (3) or (4)], and release the

button when the frequency starts scrolling.

The frequency will stop scrolling automatically on the first station it

picks up.

•

When there is outside interference, the radio sometimes stops on

a certain frequency where no station is broadcasting.

To stop auto tuning

Press either [TUNE/TIME ADJ (1 1 1 1 1 ) or (2 2 2 2 2 )] again.

If noise is excessive in the FM stereo mode A

Press [g/(, FM MODE/BP]. ("MONO" will light up.)

Sound will be produced in monaural, but this also reduces noise.

Press the button again to cancel. "MONO" will go out.

Normally, you'll want to listen in stereo, so leave "MONO" off. This

way, you can listen to stereo broadcasts in stereo, and monaural

broadcasts in mono.

You can preset an FM station in monaural by following the steps

under "Presetting only your favourite stations" on page 12. After

selecting the station in step 1, select "MONO" with [g/(, FM

MODE/BP], then continue with steps 2 and 3.

Notes

•

If you preset stations in memory they can be easily selected from

the remote control with [//3], [-/J/4] or the numeric buttons.

1. Press [TUNER] to select the band.

2. Press [//3] or [-/J/4] to select the channel, or select the

required channel directly with the numeric buttons.

To select a two-digit channel:

Press [ 10] and then the two numbers you want within 10

seconds or so.

•

Sound is momentarily interrupted if you load/unload tapes while

listening to an AM broadcast.

PRESET.

RQT5265