HTC GL 270 HD Manuel de l'utilisateur - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HTC GL 270 HD. HTC GL 270 HD 42 pages.

Slowly pull the chassis back from the grinding head.

4.6.2

Attach the grinding head to the chassis

Push the chassis's fastener into the quick release and make sure that the red locking

hooks drop down, so the safety pins can be put in place.

Replace the vacuum hose and connect the quick release coupling to the motor. The

machine is now ready to use.

4.7

Operation

The machine's functions can be controlled using the controls on the control panel,

see Figure 3-3, page 11.

4.7.1

Connect cable to mains voltage.

Reset the emergency stop switch. See Emergency stop switch, page 18.

Turn the Power knob to "I" to activate the electronics. Hold the knob in the start

position "I" for ca 1-2 seconds.

Turn the Power knob to Off ("O") to switch off the machine.

4.7.2

The emergency stop switch, (EM-Stop) must only be used in an emergency, because it

shortens the service life of the machine's electrical components.

When the switch is pressed, all electrically-powered equipment on the machine are

turned off.

Note!

Do not use the emergency stop switch to stop the machine, except in

emergencies. As long as the emergency stop switch is pressed in, the machine

cannot be started. Reset by turning the switch clockwise. The machine can then

be restarted.

4.8

In order to keep the suction hose for the dust extractor and the power cable out of the

working area and/or path of the machine, the hose and cable can be arranged as shown

in the picture below.

HTC GL 270 HD

2.0