DIBSIES MY ANYTIME CHAIR Manuel d'assemblage - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage pour {nom_de_la_catégorie} DIBSIES MY ANYTIME CHAIR. DIBSIES MY ANYTIME CHAIR 4 pages.
Imprimer la page
INSTRUCTIONS
Step 1 - Inserting the Part C (Thinner) Foam Block
1.
Prepare Part A Cover
Place the slip cover (Part A) on a flat
surface and make sure it is unzipped.
Locate three pairs of white fabric
flaps inside the cover and make sure
they are unfastened from each other.
Step 2 - Inserting the Part B Round Foam Blocks
Prepare Part B Round
1.
Foam Block
Turn chair upside down. Locate
one Part B Round Foam Block
and prepare to insert it into slip
cover to form one armrest.
Insert Part C Foam Block
2.
to form back of chair
Locate the Part C Foam Block (this is
the thinner rectangular foam block).
Insert it into the back of the slip cover
as shown.
Ensure Part C is held
securely in place with the
Ensure round foam block
2.
is secure
Insert the round block at an angle
as shown. Secure in place by
fastening together the two white
fabric flaps.
Ensure both Part B blocks
are held securely in place
with the white fabric flaps
3.
Adjust cover to ensure
foam block is snug
Adjust the slip cover to ensure tight fit.
Pull back slightly on the seam closest
to the handle until handle is tilting
towards the back of the chair. Then
fasten together the two white fabric
flaps inside cover.
white fabric flaps.
3.
Repeat these steps for other
armrest.
Locate the other Part B Round
Foam Block and repeat the previous
steps to secure the round foam
block into place.
3