Dickinson Sea-B-Que Manuel d'instruction - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Dickinson Sea-B-Que. Dickinson Sea-B-Que 16 pages.
Également pour Dickinson Sea-B-Que : Manuel d'utilisation et d'installation (16 pages)
Imprimer la page7
Getting to Know your Sea-B-Que
Thermometer:
The Large and Small Sea-B-Que are fitted with a thermometer. If you
remove the thermometer for cleaning or replacement, see below for re-
assembly diagram. Inspect the thermometer to ensure no small white bits of
plastic are around the edge, left over from the protective plastic used in the
manufacturing process. Be aware that bending or damaging the thermometer
probe or dropping the Sea-B-Que, may cause the thermometer to stop
working. (use #6 x ¼ screws)
Spark Igniter: (Large model only)
The igniter probe should be as close to the holes in the burner as possible.
See diagram below.
For a perfect fit, adjust the probe so that it is
3/16ths"(4.75mm) away from the holes. Igniters seldom fail but if yours
stops working try cleaning the probe. Built up grease may have coated the
probe, preventing the spark. Remove the igniter, clean the bracket and
around the base, the copper line on the side of the igniter and the screws.
Built up grease may have interrupted the ground. (use #8 x 3/8 screws & #8
nuts)
Orifice Assembly:
The orifice assembly is the series of brass fittings that attach to the gas
regulator control and go inside the end of the burner. The orifice has a tiny
hole that controls the maximum amount of fuel allowed to enter the burner.
From time to time salt or other debri may plug the hole changing the flame.
The Sea-B-Que will not get hot, and a blocked orifice may be the reason.
Remove and clean with a very small wire (twist tie). Do not expand the hole
or the Sea-B-Que will burn too hot.