Dickinson 2 Burner Drop In Manuel d'installation, d'utilisation et d'entretien - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Dickinson 2 Burner Drop In. Dickinson 2 Burner Drop In 15 pages.

Imprimer la page

POT HOLDERS AND RAIL

There is a set of potholders and a potholder rail standard with your appliance. The rail is

attached, as shown in the diagram, by inserting the legs into the grate and tightening the brass

thumbscrews. The grate can be removed and turned to position the sea rail at the back or front as

required. The potholders are then slipped over this rail and moved to fit the size of pot or pan by

squeezing the end legs so they can slide back and forth. Should the potholders become loose

simply spread the legs a little and they will again become secure. It is recommended that the

potholders be used when any boat motion is anticipated. The rail can be detached and stored

under the fitted cutting board.

CUTTING BOARD ACCESSORY

The board is used to provide a flat finished surface at counter top level.

useful cutting-board feature that can be used in place or elsewhere.

CUTTING BOARD LEVELING FEATURE

At the four outside corners of the cooking grate there are small tapped holes. If your counter top

is not absolutely flat the cutting board will not lie flat on the grate. By installing 4 – 8-32 screws

into the tapped holes, with the screw head up, the cutting board can be leveled. It is advisable to

tighten the levelers with a nut on the underside to secure them in place

BURNERS

The top surfaces of the burner caps are porcelain enameled to prevent oxidation (rusting) and to

provide an attractive finish.

FLAME DISPERSION

The burner ring spreads the flame evenly around the burner perimeter. This burner assembly

must be seated properly into the base to produce the desired flame configuration.

Triple Burner

These burners are CGA/AGA approved

It also provides a