Dickinson Propane 2Burner Drop-in Cooker Manuel d'installation, d'utilisation et d'entretien - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Dickinson Propane 2Burner Drop-in Cooker. Dickinson Propane 2Burner Drop-in Cooker 15 pages.

Imprimer la page

Use the mildest cleaner available to perform the cleaning operation. Use only a sponge and soft

cloth, fibrous or nylon pad for cleaning. Do not use abrasive cleaners such as steel wool.

Always dry components completely before using the cook top.

CLEANING ORIFICE

The orifices of both burners are easily accessed. The large burner cap and body is simply lifted

off the burner base support. This reveals the small hole which is the gas inlet orifice. The small

burner cap is unscrewed counterclockwise. Remove the two small screws on top of the burner

base and then lift off the assembly. It is advisable to unscrew and remove the orifice for cleaning.

Cleaning the orifice in place may result in a repeat blockage soon after re-using the cook-top.

LOWER COMPARTMENT

The lower compartment can be accessed when the appliance is removed from the

countertop cut-out. This compartment should be accessed for igniter box

replacement, thermocouple replacement, sparker wire shorting or replacing, or for

cleaning after a large spill.

Remove the two control knobs by pulling them off.

• Remove the left hand burner top by lifting it out.

• Remove the right hand burner by unscrewing the burner cap and removing

the two screws that hold the burner down .

• Remove the four stainless sheet metal screws on the outside panels of the

Cook Top.

• The top of the appliance will now lift off.

TROUBLE – SHOOTING GUIDE

No gas to burners

Poor quality flame

Low flame

Igniter does not spark.

Cutting Board uneven

Pot Holders are loose

Supply tank empty

Shut-off valve closed

Burner orifice blocked

Burner top not installed correctly

Dirt in the fuel line

Partially blocked orifice

Supply tank low pressure

Partially blocked orifice

Igniter generator battery requires replacing (9v)

Igniter box replacement

Electrode sparker wire shorting or needs replacing

See Cutting Board Leveling Feature above

Spread legs by hand