Alpha IP FAL 41011-06 Manuel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Alpha IP FAL 41011-06. Alpha IP FAL 41011-06 17 pages.

Configuration

9 The base stations are coupled.
3. A room control unit can now be taught-in to the heating zones of the second base station, as de-
scribed in section 7.1 / 7.1.1.
7.4

Teach-off of the room control unit from a heating zone

1. Choose the channel through which the room control unit shall be taught-off, by a short press of the
Select key (B). Pressing 1x = HZ1 / Pressing 2x = HZ2.... Pressing 10x = HZ10
2. Press the System key (A) and the Select key (B) simultaneously until the LED of the system key (A) of
the base station lights up in green.
If the room control unit is logged on to several Alpha IP base stations, this process must be
repeated for every base station.
3. Resetting the room control unit to factory settings (see manual of the respective room control unit).
7.5

Teach-in with Alpha IP Access Point

For a control via the Alpha IP app, the teach-on of the Alpha IP base station must be performed via the
Access Point (HAP 21001). Teach-in the device as follows:
9 The Alpha IP Access Point has been set-up via the Alpha IP app (see manual HAP 21001).
1. Open the Alpha IP app on your smart phone.
2. Select the menu item Teach-in device.
3. Press the System key (A) shortly until the LED flashes slowly in orange. The teach-in mode is active
for three minutes.
4. The device will be displayed automatically in the Alpha IP app.
5. For confirmation, enter the last four digits of the device number (SGTIN) or scan the supplied QR
code. The device number can be found below the supplied QR code or directly on the device.
The LED will light up in green after a successful teach-in process. The process must be repeated
if the LED lights up in red.
6. Follow the directions of the app.
8 Configuration
The Alpha IP base station is configured via the Alpha IP room control unit Display, Display S, or via the
Alpha IP Access Point in conjunction with the Alpha IP app.
8.1

Configuration with Alpha IP room control unit Display (S)

Proceed as follows in order to configure the Alpha IP base station via the Alpha IP room control unit
Display (S):
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol "
If the room control unit is taught-in to more than one base station, select the desired base
station with the setting wheel.
12
" and confirm the selection by shortly pressing the wheel.