Alpha Moisture Systems dewSMART DS1000 Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Alpha Moisture Systems dewSMART DS1000. Alpha Moisture Systems dewSMART DS1000 15 pages. Dewpoint meter

Imprimer la page

1. General Specification

J-

Page 3

INST ALLA TION

INSTALLING THE INSTRUMENT INTO A PANEL

Make a cut-out in the donor panel 92.0/92.8 x 45.0/45.6mm (DIN 43700).

The maximum panel thickness is 10mm and, if an effective IP65 weatherproof seal is

required, the minimum recommended panel thickness is 1.6mm.

Pass the instrument cabinet through the cut-out in the donor panel and slide the panel

clamp over the instrument, from the back, ensuring that the narrow section is at the top.

Screw the panel clamp retaining screws into the instrument cabinet until the instrument is

clamped in position. The screws must be tightened sufficiently to effect a seal between

the front of the donor panel and the back of the instrument bezel, but never over tightened

to the point of fracturing the panel clamp or instrument case.

FREE STANDING CABINET (If Applicable)

Remove the 4 screws at the sides ofthe cabinet and remove the cover.

Remove the plug-in connectors from the back of the instrument.

Pass the instrument

through the cut-out in the front of the cabinet chassis and slide the panel clamp, from

inside the chassis, over the back of the instrument, ensuring that the narrow section is at

the top.

Ensure that the connector sockets at the back of the instrument are correctly located in the

cut-outs provided.

Enter a No.2 pozidriver through the 2 round holes at the back of the chassis and screw

the panel clamp retaining screws until the instrument is firmly clamped in position in the

chassis.

Refit the cabinet cover, replace the retaining screws and refit the plug-in connectors.

The plug in cable connectors are NOT interchangeable, therefore ensure

that the three 5 pin connectors are kept in the appropriate slots.

NOTE

INSTRUMENT WIRING

Please refer to the electrical connections diagram on page 11.

POWER SUPPLY

Connect the power supply cable to the orange coloured terminal block and observe

polarity.

pi-..

The power supply should be between 90 and 250V AC @ 50/60Hz.

NOTE

Wires are retained by screws. Ensure that the exposed section of the wire

is fully inser1ed and that no loose strands are exposed.

.......

DOC:

DsrOOOIDT20.3-J-O