Axis M7016 Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Axis M7016. Axis M7016 15 pages. Video encoder

AXIS M7016 Video Encoder

Note

75 Ohm video termination can be enabled/disabled for the video input via the product's

web page at Video & Audio > Video Input > Video termination. This termination is enabled

on factory default. In cases where the product is to be connected in parallel with other

equipment, for optimum video quality, it is recommended that termination be enabled for

only the last device in the video signal chain.

Network connector - RJ45 Ethernet connector.

NOTICE

The product shall be connected using a shielded network cable (STP). All cables connecting

the product to the network switch shall be shielded (STP) and intended for their specific

use. Make sure that the network switch is properly grounded. For information about

regulatory requirements, see Regulatory Information, on page 2 .

SD card slot - A standard or high-capacity microSD card (not included) can be used for local

recording with removable storage.

NOTICE

To prevent corruption of recordings, the SD card should be unmounted before removal. To

unmount, go to Setup > System Options > Storage > SD Card and click Unmount.

Control button - The control button is used for:

•

Power connector - 2-pin terminal block for power input. Use a limited power source (LPS) with

either a rated output power limited to £100 W or a rated output current limited to £5 A.

RS-485/RS-422 connector - Two 2-pin terminal blocks for RS-485/RS-422 serial interface used to

control auxiliary equipment, e.g. PTZ devices.

Specifications

The casing of AXIS M7016 is not approved for outdoor use. The product may only be installed in

indoor environments.

Resetting the product to factory default settings. See page 11.

Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic

DNS Service. For more information about these services, see the User Manual.