3Com 3CNJ1000 - IntelliJack Gigabit Switch Manuel de démarrage rapide - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} 3Com 3CNJ1000 - IntelliJack Gigabit Switch. 3Com 3CNJ1000 - IntelliJack Gigabit Switch 16 pages. 3com intellijack nj1000: quick start

Imprimer la page

1. Quick Start Guide

5. Set Up the Network Cabling

The network cabling (from the wiring closet to the wall opening) may already be

installed. If it is not, install the cabling following these general guidelines.

CAUTION: 3Com recommends that a professional cable installer perform these

procedures. Be sure to adhere to local safety and regulatory codes during the cable

installation.

Connect one end of an Ethernet cable to the network. Usually, this

connection is made in a network wiring closet, via the patch panel.

Terminate the other end of the cable at the location where the

NJ1000 is being installed (using either a female or male RJ-45

connector). Refer to the connector manufacturer's instructions for

terminating the cable. Be sure to test the connector and verify that it

is working.

6. Connect the NJ1000 to the Network

The method for connecting the NJ1000 to the network is determined by how the

network cable is terminated, as described in step 5.

If the end of the cable is terminated with a female RJ-45 connector, use one of

■

the RJ-45 coupler cables included in the NJ1000 package to connect the NJ1000

to the network cable.