Alpha Outback Energy APX2PLUS-615G Manuel de l'utilisateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Alpha Outback Energy APX2PLUS-615G. Alpha Outback Energy APX2PLUS-615G 8 pages. Non-standby cable tv power supply
The Alpha and Outback Energy APX2PLUS-615G is housed in powder coated aluminum enclosure
which use metal hardware. All interior and exterior metal parts have smooth surfaces with rounded
corners. There are no sharp metal corners or edges that could cause injury to any personnel.
When properly installed, the entire exterior of the housing is at ground potential and no shock or
electrical hazards exist.
When the housing lid is open for set-up, maintenance, servicing etc., potentially harmful AC voltages
may be present at many contact points inside the housing. Please become familiar with the internal
circuits and the voltages that exit at all points of potential contact before any work is begun.
Field personnel must be aware of these hazards and caution should be exercised to avoid contact with
all contact points throughout the enclosure that are not at direct ground potential (mechanically
fastened to the housing chassis).
MOUNTING:
Mount this product only as described in the installation instructions, otherwise it may fall
causing serious personal injury and/or damage the unit. Use only the bracket supplied with
the product. Do not use attachments not recommended for this product as they may cause
hazards.
SERVICING:
Remove power from this device and refer servicing to qualified personnel under the
following conditions:
1. If the inside of the station has been exposed to rain or water.
2. If the station does not operate normally by following the operating instructions.
Adjust only those controls that are covered by the operating instructions as an
improper adjustment of the controls may resul t in damage and will often require
extensive work by a qualified technician to restore the unit to its normal operation.
3. If the unit has been dropped or the chassis has been damaged.
4. If the unit exhibits a distinct change in performance.
REPLACEMENT PARTS:
When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or those that have the same
characteristics as the original part. Unauthorized substitutions may result in fire, electric
shock or other hazards.
Page 3 of 8