Die-Profi-Permament-Liner LUX Series Manuel - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Die-Profi-Permament-Liner LUX Series. Die-Profi-Permament-Liner LUX Series 13 pages.
Commissioning - Description of the device "LUX"
Important: Use only original consumables and charging parts otherwise proper service will not be
assured and the warranty will be voided!
I. Socket for original USB cable to charge the
The device must not be operated with a connected USB cable or mains!
II. Here the device is booted u. the 1st / 2nd / 3rd grades are
To boot the device, press for about 3 seconds until the red light comes on.Then the levels
can be selected.
1st stage lowest power / 2. Medium power level / 3rd level highest power
III. On and off switch at
IV. Recording of the applicator tip screw thread
1. Safety functions! Switch on / off and boot the device at switch II. To boot, press the switch for
about 3 seconds until the red light comes on. If the device is not used, the device switches off
automatically after 30 minutes!
2. Booting After booting the device, the red light will be on. Then press shortly then the lamps
will light green. All 3 lamps light up Device is 100% charged, with two lamps 75% u. loaded
with a 1 lamp 25% capacity.
3. If the device loses power, recharge the lithium-ion battery using the supplied power bank / PC
or laptop. It can be charged about 1,000 x responsive to overcharge u. Deep discharge. It must
not be discharged deep or completely.
warranty expires).
appliance heat up excessively (can be done by working on the skin or doing wrong handling so
that we overload it), switch it on and let it cool down. If the power is very low afterwards, the L-
I battery is no longer fully functional and needs to be replaced in a repair.
4. By briefly pressing the switch II. After booting, you can level III. /IV/V. choose.
5. To work with the device, press the IV key. Push and to end the work release the Push button.
The device is then ready for 30 minutes and then switches off when not in use. Can be put into
operation again at any time by pressing the button IV. Out.
6. Attach the applicator tip A using the needle holder and remove it again. The applicator tip B can
be easily screwed on and removed.
7. When working, the applicator must not be placed on the skin! The device may and may only be
put into operation without a cable. If you do not comply with this and use the device with a
mains adapter / mains cord, the device may be damaged, the guarantee expires and you are
liable for any damage that may occur.
8. When disinfecting the device with disinfectants, the instructions for use of the disinfectant
manufacturer must be strictly adhered to. It must not dissolve paint, metals or plastic.
Otherwise, under certain circumstances, the warranty may expire here.
These pages are sole property "Die-Profi-Permanent-Liner", copies or duplications are not permitted without permission. In
the case of misuse, a complaint with claim for damages will be made immediately!
battery_________________________________________________
work_______________________________________________________________________________
Therefore, charging should be done from 25% to about 75%. Should the
Seite 5
Medical
©
chosen_________________________________
_______________________________________________________
There is a risk that its function will be limited (here the
1992-2019
©
Seite 6